Sonance Silhouette I - Installation Quickstart and Parts List

13
PARTS LIST / TOOL LIST
Drywall Screws (not included)
NEW CONSTRUCTION RETROFIT
PARTS
Phillips Bit
1" Flat Bit
Stiff Wire (coathanger, fishtape)
Electric Drill (1/4" - 3/8" drive)
Wire Strippers
Torpedo Level
TOOLS
Keyhole or Drywall Saw
Gloves
Construction Adhesive
(not included)
Silicon Sealer (not included)
Eye Protection Goggles
INSTALLATION QUICK START
Read “Getting The Most From Your Sonance Silhouette Speakers” and plan speaker locations.
If this is your first installation of a Sonance Silhouette system, read all of the installation instructions
before beginning.
Choose high quality (oxygen-free, multi-strand) copper wire to make the wire runs between your
audio equipment and your Sonance Silhouette speakers. Larger wire than normal is recommended. to
reduce resistance which eliminates power losses between your audio equipment and your in-wall
Sonance Silhouettespeakers. Follow the information listed below:
• 14 gauge for less than 30 feet.
• 12 gauge for between 30 and 75 feet.
• 10 gauge for greater than 75 feet.
Verify adequate parts and tools for the installation:
Chart A. Installation Parts and Tools List for Sonance Silhouette speakers.
33-1823 Silhouette Manual 2/16/00 1:36 PM Page 13