VISUAL PERFORMANCE
®
RECTANGLE SPEAKERS
Stereo Speaker Placement (2-Channel System)
speakers as possible.
side walls.
stereo soundstage.
Use the left and right speaker placement in Figure 4, as a guide.
2. The speaker’s terminals are spring-loaded. Push the top
of each terminal down to open the connector and insert
the exposed wires into the holes in the spring terminals. The
3. Make sure all the Roto-Lock toggle feet are retracted so that
speaker into the hole in the wall (Figure 5
can accommodate a wall material thickness of 1-1/4”
(32mm)
accommodate a wall material thickness of 1-7/8”(48mm).
(Figure 6).
Installation
Sonance Visual Performance Series speakers feature an integral
Roto-Lock
®
existing walls.
lead. Twist the strands or tin the exposed wire with solder to
Before Installation: Retrofit
on page 1 & 2).
there are no studs, conduit, pipes, heating ducts, pocket doors or air
unsure about obstructions, drill a small hole in the center of the
outline and insert a coat hanger wire into the hole to feel around for
possible obstructions.
run the speaker wires from the mounting hole to the amplifier
location.
2
To Next Page
Loading...
