Need help?Do you have a question about the Sonel TDR-420 and is the answer not in the manual?
General| Pulse Width | 3 ns to 3 μs |
|---|---|
| Battery Life | Up to 8 hours |
| Operating Temperature | -10°C to +50°C |
| Storage Temperature | -20°C to +60°C |
| Ingress Protection | IP54 |
| Velocity of Propagation (VoP) | 1% to 99% |
| Output Impedance | 50 Ω |
| Display | 320 x 240 pixels, color LCD |
Configure the unit for the velocity of propagation (VoP) setting.
Select the desired unit for measuring cable length (meters or feet).
Adjust the display brightness to optimize battery life and visibility.
Configure the automatic power-off timer to conserve battery.
Choose the interface language for the device.
Configure essential parameters like impedance, VoP, and range for accurate fault detection.
Set the wave impedance value, crucial for accurate fault location on specific cables.
Input the Velocity of Propagation for precise distance measurements.
Amplify waveform details for better analysis, especially on long cables.
Access examples of waveforms for identifying common cable defects.
Understand factors affecting accuracy, including VoP and cursor placement.
Check the battery status indicator for current charge level.
Procedure for safely replacing the device's power source.
Guidelines for optimal use, storage, and charging of Ni-MH batteries.
To Next Page
