SonicWALL NSA 2650 - Safety Instructions; Installation Requirements

48
SonicWallNSA2650Get tingStartedGuide
SafetyInstructions
• InstallationRequirementsonpage48
• LithiumBatteryWarningonpage49
• CableConnectionsonpage49
InstallationRequirements
WARNING:
Thefollowingconditionsarerequiredforproperinstallation:
1TheSonicWallapplianceisdesignedtobemountedina
standard19‐inchrackmountcabinet.
2Usethemountinghardwarerecommendedbytherack
manufacturerandensurethattherackisadequatefor
theapplication.
3Ensurethatnowaterorexcessivemoisturecan
enter
theunit.
4Allowunrestrictedairflowaroundtheunitand through
theventsonthesideoftheunit.Aminimumof1inch
(26mm)clearanceisrecommended.
5Routecablesawayfrompowerlines,fluorescent
lightingfixtures,andsourcesofnoisesuchasradios,
transmitters,andbroadbandamplifiers.
6Mountinalocation
awayfromdirectsunlightand
sourcesofheat.Amaximumambienttemperatureof
104ºF(40ºC)isrecommended.
7Ifinstalledinaclosedormulti‐rackassembly,the
operatingambienttemperatureoftherack
environmentmaybegreaterthantheroomambient.
Therefore,considerationshouldbegiventoinstalling
the
equipmentinanenvironmentcompatiblewiththe
maximumrecommendedambienttemperature.
8MounttheSonicWallappliancesevenlyintherackin
ordertopreventahazardousconditioncausedby
unevenmechanicalloading.
9Fourmountingscrews,compatiblewiththerackdesign,
mustbeusedandhand‐tightenedtoensuresecure
installation.Choosea
mountinglocationwhereallfour
mountingholeslineupwiththoseofthemountingbars
ofthe19‐inchrackmountcabinet.
10 Asuitablyratedandapprovedbranchcircuitbreaker
shallbeprovidedaspartofthebuildinginstallation.
Followlocalcodewhenpurchasingmaterialsor
components.