8.Record/Play a Track
Once you have the software setup and the MIDI
output from the pedal mapped (for mapping please
see the Sonnit Software manual) you are ready to
record.
Record Using individual track Buttons
First select Record Mode by pressing the Mode
button until the red LED above the Rec/Play All
pedal lights. To record directly to a track you can
press one of the Track buttons (1-4). This will begin
recording the first loop on the track button that’s
pressed e.g. if you press the Track 2 your first loop
will be on Track 2. Once you finish your loop press
the same button used to start the loop to end and
enter Overdub.
You can now either continue to overdub the track or
press the track button again to start Play. Now you
have your first track recorded if you have selected
‘Synced' (for sync modes please see the Sonnit
Software manual) as your record mode all the other
track lengths will now be set the length of the first
track recorded.
Record Using Selected Track
You can also Record/Overdub/Play using the
Record/Play All Pedal. This will
Record/Overdub/Play the selected track (highlighted
in green in the Sonnit Software).
To begin a new recording switch the pedal to Play
Mode by pressing the Mode button until the red LED
above the Rec/Play All button is not lit. Now select
the track you want to start your recording on (using
the Track 1-4 buttons). The track you select will
highlight green in the Sonnit Software. Now press
the Mode button again to return to record Mode
(LED above the Rec/Play All button will be lit). Now
by pressing the Rec/Play All button the software will
begin recording on the selected track. Once you
have finished your loop press the Rec/Play All
button again to finish the recording and enter
Overdub. The Rec/Play All button will act as the
individual Track buttons do for any selected track.
To Next Page
Loading...