17CARE AND MAINTENANCE
REPLACING THE HEADBAND PAD
The headband pad is held in place by
the small plastic tabs marked L and R on
each side of the headband. To remove one
of the tabs, use your thumb to carefully
push the sidewall outwards (do this at the
thicker part as indicated). As you push the
sidewall out, pop the tab out.
With the tab removed, grasp the old
headband pad and slide out of the
headband as indicated.
The new headband pad needs to be
inserted into the slot within the headband
rail, and then carefully moved around
the headband until the end reaches
the in-place tab on the other side of the
headband.
When the new headband is fully in place,
press the removed tab back into the
headband to lock the pad in place.
To Next Page
Loading...
