13
When battery goes down, it is necessary to recharge the Meter. Pull
the insertion at the end of the device, and then connect the USB Charger
and USB Cable with the Meter to charge the Meter as shown in figure
7-1. When in charging, the battery indicator light will be red, the flash
sign will be blinking and the lighted battery bar indicates the capacity of
the battery charged.
Figure 7-1 charge the Meter
After seconds, the screen will turn to sleeping mode.
To see the status of charging, you should press the ‘Power/Scan’
button.
If the battery indicator light turning off means the battery is fully
charged. Unplug the USB cable and the insertion should be carefully
plugged.
Note: When in charging, the device cannot be started up.
To Next Page
Loading...
Need help?
General