Sontex Superstatic 789 User Manual

0789P300-E Installation Superstatic 789 EN 29-05-2017 8 Sontex SA, 2605 Sonceboz, Switzerland
Security seals
As sealing varies from country to country, local regulations must be followed. To protect the system against all unauthorised manipulations, the energy
meter, the connection screws, the temperature sensors and the sensor pockets must all be sealed. The seals may only be removed by authorised persons.
In the event of failure to comply with this instruction, the guarantee obligation will lapse. It is important for the wire seal to be as short as possible so that it
is slightly taut. This is the only way of preventing malicious interference.
A factory seal (2) will be applied to the temperature sensor mounted in flow meter. To mount the temperature sensor on the other side of the installation,
the Sontex seal (S written in black on a grey background). or wire seal supplied with the meter must be used.
The detector support fitted on the flow sensor can’t be removed without being damaged or broken.
Position of the seals:
Seals installed in the factory on flow meter (1) and temperature sensor (2) of the Superstatic 789
Metrological seal applied in the factory on the integrator
2
1

Sontex Superstatic 789 Specifications

General

Brand	Sontex
Model	Superstatic 789
Category	Measuring Instruments
Language	English