This is the Internet version of the user's guide. © Print only for private use.
35
Calling
To activate voice answering and
record voice answer commands
1 } Settings } the General tab } Voice control
} Voice answer } Activate.
2 Instructions appear. Press Continue and lift the
phone to your ear. Wait for the tone and say
“Answer”, or another word. If the recording
sounds ok, press Yes. If not, press No and
repeat step 2.
3 Say “Busy”, or another word. Press Yes.
4 Instructions appear. Press Continue and select
the environments in which you want voice
answering to be activated. You can select
several alternatives.
To answer a call using voice
commands
When the phone rings, say “Answer” and the call
is connected.
To reject a call using voice
commands
When the phone rings, say “Busy”. The call is
rejected. The caller is diverted to voicemail,
if activated, or hears a busy tone.
Editing your voice commands
You can keep all your voice commands up to date
by re-recording them or deleting the ones you do
not use. You can also edit a voice command for a
phone number in the phonebook. Select the contact
you want to edit a voice command for, press More
} View & edit, and select .
To re-record a voice command
1 } Settings } the General tab } Voice control
} Voice dialling } Edit names.
2 Select a voice command, press More
} Replace voice.
3 Lift the phone to your ear, wait for the tone and
say the command.
Tips when recording and using
voice commands
If your phone cannot detect speech, one of the
following might have happened:
• You spoke too softly – try speaking louder.
• You held the phone too far away – hold it as
you do during a call.
• The voice command was too short – it should
be around one second long and more than
one syllable.
To Next Page
Loading...
