74
Trouble check
Picture
Symptom Cause and/or Corrective Actions
• The START/STOP MODE switch is set to 5SEC or .
m Set it to . (p. 16)
• The battery is dead.
m Use a charged battery pack or the AC power adaptor.
(p. 8, 26)
• Moisture condensation has occurred.
m Remove the cassette and leave the camcorder for at least
1 hour. (p. 67)
• You pressed DATE and TIME together for more than 2
seconds.
m The camcorder is not malfunctioning. You may start
recording. Flashing will stop soon.
• The lithium battery is weak or dead.
m Replace the lithium battery with a new one. (p. 59)
• The POWER switch is set to CAMERA or OFF.
m Set it to VTR/PLAYER.
• The tape has run out.
m Rewind the tape or use a new one. (p. 22)
• STEADYSHOT is set to OFF.
m Set it to ON. (p. 53)
• The Steady Shot function does not work when the wide
mode is set to 16:9 FULL.
• FOCUS is set to MANUAL.
m Set it to AUTO. (p. 43)
• Shooting conditions are not suitable for autofocus.
m Set FOCUS to MANUAL to focus manually. (p. 43)
• The START/STOP MODE switch is set to 5SEC or .
m Set it to . (p. 16)
• The stereo tape is played back with HiFi SOUND set to 1
or 2 in the menu system.
m Set to STEREO in the menu system. (p. 33)
• The picture has been recorded with WIND set to ON in
the menu system.
m When there is no wind, set it to OFF. (p. 31)
• Reset the date and time. (p. 61)
Recording stops in a few seconds.
The date or time indicator
disappears.
Excessive high-pitched sound is
heard. (CCD-TRV65/TRV615 only)
The fader function does not work.
(CCD-TRV35/TRV65/TRV315/
TRV615 only)
The autofocusing function does not
work. (CCD-TRV35/TRV65/
TRV315/TRV615 only)
The Steady Shot function does not
activate. (CCD-TRV25/TRV35/
TRV65/TRV215/TRV315/TRV615
only)
The tape does not move when a
video control button is pressed.
No sound or only a low sound is
heard when playing back a tape.
(CCD-TRV65/TRV615 only)
The date or time indicator is flashing.
{ and 6 indicators flash and no
function except for cassette ejection
works.
The cassette cannot be removed from
the holder.
Symptom Cause and/or Corrective Actions
• The viewfinder lens is not adjusted.
m Adjust the viewfinder lens. (p. 14)
The image on the viewfinder screen
is not clear.
To Next Page
Loading...
Need help?
General