Sony CDP-101 - Display Window and Rear Panel Controls

\ When you release this button, normal-speed play will resume (dur-
yt ing play) or the player will return to the pause mode (during pause).
4< button: To go backwards at a high speed (several times
higher than the normal playing speed).
| 444 button: To go backwards at a higher speed than the <4
button.
be button: To skip ahead at a high speed (several times
higher than the normal playing speed).
PPP button: To skip ahead at a higher speed than the pp
button.
CDP-101
@® » PLAY button and indicator
Press
to
start
normal
disc
play.
The
built-in
®
indicator
will
il-
luminate.
® 11 PAUSE button and indicator
Press
to
pause
during
play.
The
built-in
48
indicator
will
illuminate.
To
release
the
pause
mode,
press
this
button
again.
The
indicator
will
go
off
and
disc
play
will
resume.
@ RESET button
When
this
button
is
pressed,
disc
play
is
reset
to
the
very
beginning
of the first selection and the player stands by.
| Display window
| @® isc SET indicator
@ TRACK No. indicator
@ SCAN indicator
a a ei
| Lf il
TRACK NO MINUTE SECOND
th SCAN
| ©
DISC SET
@ Time counter
® DISC SET indicator
The indicator flickers when the disc compartment is moving.
When the disc compartment has closed with a disc in place (in the
standby mode), and during disc playing, the indicator illuminates
steadily.
@® TRACK NO. indicator
The indicator shows the track number of the selection being
played.
If you press the B® or BR button at the end of the disc, the in-
dicator will change to “7 7” indicating that the end of the last
selection has been reached. To return to a previous selection
number, press the RESET, Me, <4 or <q button. If you press the
<4 or <4 bution at the beginning of the disc, the indicator wil!
change to “/ /£”, indicating that the beginning of the first selec-
tion has been reached. -
@ SCAN indicator ‘
This indicator illuminates while the player is searching for the point
on the disc you have programmed.
@® Time counter
The counter shows the location in a particular selection by means
of actual elapsed time. The first two digits of the counter show
playing time of the selection in minutes, and the last two digits
show the seconds.
-
Rear panel
® SYNC OUT (Synchro remote control output) jack
— only AEP and UK model —
(oe model: up to Serial No. 501 neo)
UK model: up to Serial No. 600,300
€) ACCESSORY connector
@ AUTO PAUSE switch
i
j
1
{
|
|
|
|
@ BEEP (buzzer) ON/OFF switch
' LINE OUT jacks ® ANTI SHOCK switch
© SYNC OUT (synchro remote control output) jack
— only AEP and UK mode! —
(Ge, model: up to Serial No. ee
UK model: up to Serial No. 600,300
Used for synchronized operation with Sony cassette decks. See page 20.
@ ACCESSORY connector
Used
to
extend
the
utility
of
this
compact
disc
player
by
providing
for
the
connection
of
optional
equipment
which
will
be
available
in
the
future.
:
Do
not
remove
the
cover
except
when
connecting
any
equipment
to
this
connector.
@ AUTO PAUSE switch
Normally set to OFF.
When this player is used with an optional micropnone amplifier, set
to ON to pause after naving played each selection.
This auto pause mode is released when the START key on the
Remote Commander is pressed.
@ BEEP (buzzer) ON/OFF switch (bottom)
Set to ON to have a signal tone sounded when a signal from the
supplied Remote Commander is received. Set the switch to OFF
when a signal tone is not necessary.
@ ANT! SHOCK switch
When the player is used in a place subject to excessive vibration
and the disc skips frequently, set this switch to ON.
However, when a defective disc is played with this switch set to
ON, and it may skip frequently, set this switch to OFF.
|
i
\