Sony CDP-101 - Parts List: General Hardware; Parts List: Component Categories

CDP-101
= °
Py
2
i
}
1
}
won no wre |
10
11
12
13
14
15
16
17
18
19
| 20
! 21
22
23
24
25
27
28
29
30
a 31
i 33
34
35
36
37
38
39
40
42
43
44
45
NOTE:
! * Items marked " 6" are not stocked since
! thev are seldom required for routine
Some delay should be antici-
pated when ordering these items. 1/4u,
i service.
GENERAL
Part No,
2-259-121-00
2-267-020-00
2-832-007-00
3-489-073-00
3-531-576-01
3-548-124-00
3-558-708-21
$;3-561-902-00
6;4-885-818-00
3-655-122-00
3-701-439-11
$;3-701-822-00
$;3-701-832-00
3-703-037-00
3-703-108-21
3-703-244-00
3-831-441-11
3-831-441-XX
4-015-736-00
6;4-342-117-00
6;4-342-118-00
6;4-348-551-00
4-836-836-00
4-885-829-21
4-866-397-00
$;4-854-790-00
6;4-884-504-00
4-884-505-00
4-884-506-00
4-884-509-00
4-884-510-00
4-884-511-00
4-884-512-00
4-884-513-00
4-884-514-00
4--884-515-00
4-884-516-00
4-884-517-00
34-884-518-00
é
6;4-884-519-00
6; 4-884-520-00
6; 4-884-521-00
6;4-884-522-00
6; ;4-884-523-00
6;4-884-524-00
Items with no part number and no des-
cription are not stocked because they
are seldom required for routine service.
* Due to standardization, parts with part
numbers (A-AAA-AAA-XX or A-AAAA~AAA-X)
SECTION
Description
SCREW, TR
SPRING, COMPRESSION
BUSHING (K), INSULATING
SCREW, THRUST
RIVET
SPRING, TENSION
WASHER, STOPPER
CLOTH, RETAINING, CASSETTE
SPACER
TIRE, S BRAKE
WASHER
HOLDER, WIRE
HINGE, CIRCUIT BOARD
INSULATOR, TO-220
SCREW +BV 3X6, S TIGHT
BUSHING, CORD
SHEET, ESCUTCHEON
FELT
CUSHION, CHASSIS
CASE, SHIELD (MAIN), R
LID, SHIELD CASE, R
PLATE, SHIELD
SPRING, COMPRESSION
BOLT (M2. 6X6)
CUSHION, LED
HEAT SINK
HOLDER, CONNECTOR
RETAINER
ROLLER
SHAFT, SLIDE
GEAR (A)
GEAR (8)
GEAR (D
SPRING (A)
WASHER
SPRING (RACK), COMPRESSION
RETAINER (LEFT), SLIDE SHAFT
RETAINER (RIGHT), SLIDE SHAFT
BRACKET (A), CHASSIS
RETAINER, ESCUTCHEON
STOPPER (D), CHASSIS
BEARING, EJECT KNOB
BRACKET ate CATCHER, RAY
BRACKET (B), CATCHER, RAY
BRACKET, JACK
CAPACITORS:
* All capacitors are in uF.
pacitors are omitted.
following lists for their part numbers.
MF: uF, PF:uuF.
RESISTORS
may be different from those used in the °F
set.
COILS
* MMH : mH, UH :
are omitted.
: nonflammable
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87 @
GENERAL SECTION
Part No.
4-884-525-00
4-884-526-00
4-884-528-00
4-884-533-00
4-884-535-00
4-884-536-00
6;4-884-538-00
$;4-884-539-00
4-884-540-00
4-884-542-00
4-884~543-00
4-884-544-00
6;4-884-545-00
6;4-884-546-00
;4-884-547-00
4-884-548-00
6;4-884-550-00
4-884-554-00
4-884-555-00
4-884-556-00
6;4-884-557-00
4-884-558-00
4-884-559-00
4-884-560-00
4-884-561-00
4-884-562-00
4-884-564-00
4-884-567-00
4-884-570-01
*4-884-570-11
4-884-570-21
4-884-572-00
4-884-573-01
4-884-573-11
6;4-884-580-00
6;4-884-581-00
6; 4-884-582-00
6; 4-884-583-00
4-884-584-00
;4-884-585-00
6;4-884-586-00
6;4-884-587-00
6;4-884-588-00
$;4-884-594-00
Common ca-
Refer to the
- All resistors are in ohms.
1/8W and 1/16W carbon resistors
Refer to the following
lists for their part numbers.
—7 6—-
Common
- BRACKET
Description
ESCUTCHEON (B), PANEL
GEAR (A), THREADING
GEAR (B), THREADING
GEAR {f » CHUCKING
GEAR (B), CHUCKING
GEAR (C), CHUCKING
BRACKET (B), MOTOR
LEVER, CHUCKING CAM
CAM, CHUCKING
RACK
SCREW, RACK
SPRING
PLATE a} STOPPER, ROLLER
PLATE (B), STOPPER, ROLLER
PLATE (C), STOPPER, ROLLER
STOPPER, PRESS PULLEY
SHAFT, CHUCKING ARM
PULLEY, DISK
CAP, CENTERING
KNOB, SLIDE SWITCH
PLATE, FIXED, WIRE
RACK {8}
RACK (B
SPRING
SHAFT (A), CAM LEVER, UP & DOWN
SHAFT (B), CAM LEVER, UP & DOWN
SPRING
RETAINER (LEFT), SHAFT
KNOB, REPEAT
KNOB, REPEAT
KNOB, REPEAT
KNOB, STOP
KNOB, CLEAR
KNOB, CLEAR
SHAFT (A), KNOB
-SHAFT (B), KNOB
RETAINER, SHAFT (A), KNOB
RETAINER, SHAFT (B), KNOB
PLATE, STOPPER
BRACKET (C), MICRO SWITCH
PLATE, DETECTION, THREADING
BRACKET (BY? MICRO SWITCH
: » MICRO SWITCH
PLATE, DISPLAY
The conoorients identified
» by shading and mark Aare
' critical for safety.
Replace only with part
number specified.
Les
composants
identifies
par
une
trame
et
une
marque
A\sont
= critiques pour la securité.
» Ne les remplacer que par
une piéce portant le numéro
SEMICONDUCTORS
In each case, U:
UPD--+: uPD-->
u, for example:
UA-++: pA-++, UPA---: pPA++:, UPC-->+: