Sony CDP-101 - Page 63

GENERAL
No. Part No.
91 #34-884-595-00
92 8;4-884-596-00
93 °4-884-597-00
94 &;4-884-598-00
95 °4-884-599-00
96 6;4-884-601-00
97 $;4-884-602-00
98 4-884-610-00
99 $:4-884-611-00
100 6;4-884-613-00
101 @;4-884-614-00
102 °4-884-615-00
i 103 4-884-616-00
104 4-884-617-00
105 4-884-618-00
106 4-884-620-00
107 4~884-621-00
108 #;4-884-622-00
109 #;4-884-623-00
110 $:4-884-624-00
11] 8:4-884-625-00
112 4~884-626-00
113 #;4-884-627-00
Ae enna
115 4-884-631-00
116 4-884-633-00
117 4-884-634-00
118 4-884-635-00
119 4-884-636-00
120 @;4-884-637-00
4 121 4-884-640-00
i 122 4-884-641-00
123 4-884-643-00
124 4-884-644-00
; 125 $;4-884-646-00
126 &;4-884-647-00
127 4-884~648-00
128 4~884-649-00
129 #;4-884-651-00
130 #;4-884-652-00
F 131 "4-884-654-00
Z| 132 $;4-884-656-00
133 6;4-884-657-00
134 6;4-884-658-00
135 4-884-660-00
|
NOTE:
are seldom required for
i * Items marked " 6" are not stocked since
| thev are seldom required for routine
I service.
8 * Due to standardization, parts with part : :
} numbers (A-AAA-AOS-XX or A-AAAA-AAA-X) Mists for Sherr: pare numbers:
ae may be different from those used in the * Fo: nonflammable
ou set.
COILS
|
*
MMH
:
mH,
UH
:
LH
Items with no part number and no des-
cription are not stocked because they
Some delay should be antici-
} pated when ordering these items.
SECTION |
Description
FILTER
ANGLE, SIDE PLATE
KNOB, CONTROL
BRACKET (A), MOTOR
CAM, LOCK
PLATE, DETECTION, DISK
STOPPER (B), CHASSIS
PLATE (RIGHT), BEARING
SHAFT, EJECT KNOB
HEAT SINK (SMALL)
HOLDER, IC
SPRING
SPRING
SPRING
SPRING
PLATE, GUIDE
SHAFT (2), SLIDE
BRACKET (E), MICRO SWITCH
REINFORCEMENT (A)
REINFORCEMENT (D
REINFORCEMENT (B
SPRING
STOPPER, CORD
COVER (C), LED
COVER, CONNECTOR
PLATE, SPRING, STOPPER
BASE, ORNAMENTAL
PLATE, GUIDE, D.P
SHEET (C), INSULATING
COVER, CORD
PLATE, ORNAMENTAL, FRAME
ESCUTCHEON (A), PANEL
HEAT SINK
RAIL (LEFT), FIXED
RAIL (RIGHT), FIXED
RAIL (RIGHT)
RAIL (LEFT)
PLATE (LEFT), SIDE
BRACKET (LEFT), FRAME
GEAR (C)
RETAINER, FUNCTION PANEL
PLATE (RIGHT), CAM, UP & DOWN
PLATE (LEFT), CAM, UP & DOWN
LEVER, FUNCTION
CAPACITORS :
routine service.
MF: uF, PF:uuF.
RESISTORS
1/4W,
are omitted.
- All capacitors are in uF.
pacitors are omitted.
following lists for their part numbers.
- All resistors are in ohms.
1/8W and 1/16W carbon resistors
Refer to the following
GENERAL
No. Part No.
136 4~-884-664-00
137 @;4-884-665-00
138 6;4-884-667-00
139 4-884-669-00
140 = 4-884-672-00
141 4-884-675-00
| 42 $;4-884-676-00
150 @ ;4-884-688-00
151 6 ;4-884-689-00
[143 $;4-884-677-00
144 4-884-678-00
145 6;4-884-682-00
146 =4-884-683-00
147 4-885-825-00
147 = 4-885-827-00
147 = 4-885-828-00
148 @;4-884-686-00
149 4-884-687-11
149 = 4-884-687-31
149 4-884-687-32
149 4-884-687-41
149 4-884-687-42
4-884-687-51
152 °4-884-693-00
153 ;4-884-694-00
153 6 4-885-824-00
154 & ;4-884-696-00
155 8 :4-884-697-00
156 4-884~-698-00
|157 4-884-699-00
158 4-885-829-00
159 7-621-284-10
160 7-621-592-00
161 7-621-734-09
162 7-623-924-11
163 7-624-104-04
164 7-624-106-04
1652 cisecewrectes
l166 7-624-190-81
167 7-671-156-01
168 7-682-144-01
169 7-682-145-09
170 7-682-146-01
71. laseciceeaces
Common ca~
Refer to the
Common
—7F]—
-pp- 101
SECTION
Description
BASE, OP
PLATE (RIGHT), SIDE
PANEL, SUB
BASE, FUNCTION PANEL
TABLE, DISK
SHAFT, SEESAW
SPRING, RETAINER
LEVER, SEESAW
PANEL, FRONT
REINFORCEMENT (E)
LEAF, SPRING, GROUND
(US,Canadian)..LABEL, MODEL NUMBER (U,CND)
UK) eceeeeece . LABEL, MODEL NUMBER (uk)
AEP). cceveeees LABEL; MODEL NUMBER {AEP1)
PLATE, BOTTOM
(UST sa Puscddscw cs PLATE, JACK
(AEP:UP TO SERIAL No. 501000)...PLATE, JACK
(AEP:SERIAL No. 501001 AND LATER)
«PLATE, JACK
UK: UP TO SERIAL No. 600300)....PLATE, JACK
UK:SERIAL No. 600301 AND LATER)
ee+PLATE, JACK
(Canadian) .....e0- PLATE, JACK
BRACKET (RIGHT), FRAME
(AEP,UK).--++++eLABEL, OS
PLATE, TRANSPARENT
Peppa an eRe POWER
AEP). .eeseeee+sCOVER, POWER
BRACKET (D), MICRO SWITCH
COVER
RETAINER(LOWER)(2), SLIDE SHAFT
RETAINER (LOWER)(1), SLIDE SHAFT
BOLT (M2. 6X12)
SCREW +P 2.6X5
SCREW +K 2.6X6
SET-SCT, HEX. 2.6X3
WASHER 3.0, NYLONE
STOP RING 2.0, TYPE -E
STOP RING 3.0, TYPE -E
STOP RING 2, TYPE-CS
BALL, STENLESS
SCREW +P 3X3
SCREW +P 3X4
SCREW +P 3X5
The components identified
by shading and mark A\are
critical for safety.
Replace only with part
number specified.
Les composants identifiés par .
une trame et une marque /\sont : a
critiques pour la sécurité.
Ne les remplacer que par
une piéce portant le numéro
ifie
SEMICONDUCTORS
u, for example:
pPA--+, UPC-++:
In each case, U:
UA--+: pAe++, UPA+--:
UPD--+: uPD---
uPC,