Setting
the
clock
The clock uses a 12-hour digital indication.
1 Press and hold the select button.
The setup display appears.
2 Press the select button repeatedly
until "CLOCK-ADJ" appears.
3 Press
(SEEK)
+.
The hour indication flashes.
4 Rotate the control dial to set the hour
and minute.
To
move the digital indication, press
(SEEK)
-/+.
5 After setting the minute, press the
select button.
The setup is complete and the clock starts.
To
display the clock, press
(DSPL).
Press
(DSPL)
again to return to the previous display.
Detaching
the
front
panel
You
can detach the front panel
of
this unit to
prevent theft.
Caution alarm
If you tum the ignition switch
to
the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound
if
the built-in
amplifier
is
used.
1 Press
(OFF).
The unit is turned off.
2 Press
~,then
pull it off towards you.
Notes
• Do not drop
or
put
excessive pressure on the front
panel
and
display window.
• Do not subject the front panel to heat!high
temperature
ormoisture. Avoid leaving it in a parked
car
or
on a dashboardlrear
tray.
Attaching the front panel
Engage part @
of
the front panel with part ®
of
the unit,
as
illustrated, and push the left side into
position until it clicks.
Note
Do
not
put
anything on the inner surface
of
the front
panel.
-
5
To Next Page
