CDX-GT930UI/GT937UI/GT980UI
4
SECTION 1
SERVICING NOTES
EXTENSION CABLE AND SERVICE POSITION
When repairing or servicing this set, connect the jig (extension
cable) as shown below.
• Connect the MAIN board (CNP301) and the SERVO board
(CN401) with the extension cable (Part No. J-2502-076-1).
NOTE FOR THE OPENING OF THE FRONT PANEL
In this set, the front panel is lowered to below the bottom face
when it is opened.
When servicing the set, place it on a stand having a height of about
2 cm.
NOTE FOR REPLACEMENT OF THE SERVO BOARD
When repairing, the complete SERVO board (Part No. A-1554-
409-A) should be replaced since any parts in the SERVO board
cannot be repaired.
SERVO BOARD
CN401
MAIN BOARD
CNP301
J-2502-076-1
stand
To Next Page
Loading...
