— 2 —
TABLE OF CONTENTS
1. SERVICE NOTES ···························································· 3
2. GENERAL ·········································································· 4
3. DISASSEMBLY
3-1. Front Cabinet Assy ····························································· 5
3-2. Control-1, Headphone Board ············································· 6
3-3. Cabinet (Upper) Assy ························································· 6
3-4. Power, Batt, Tuner, Batt Com Board ·································· 7
3-5. Main, Line In, LCD Board ················································· 7
3-6. CD Board, Optical Pick-up Section,
Mechanism Deck ································································ 8
3-7. Belt ····················································································· 8
4. ADJUSTMENT
4-1. Mechanical Adjustment ······················································ 9
4-2. Electrical Adjustment ························································· 9
5. DIAGRAM
5-1. Circuit Boards Location ··················································· 12
5-2. Block Diagrams – Tuner/CD Section – ···························· 13
– Main Section –······························································· 15
5-3. Schematic Diagram – CD Section – ································· 18
5-4. Printed Wiring Board – CD Section – ······························ 21
5-5. Schematic Diagram – Cassette Deck Section –················ 23
5-6. Printed Wiring Board – Cassette Deck Section – ············· 25
5-7. Schematic Diagram – Tuner Section – ····························· 27
5-8. Printed Wiring Board – Tuner Section – ·························· 29
5-9. Printed Wiring Board – Main Section – ··························· 31
5-10. Schematic Diagram – Main Section (1/2) – ····················· 33
5-11. Schematic Diagram – Main Section (2/2) – ····················· 35
5-12. Printed Wiring Board and Schematic Diagram
– Control Section – ·························································· 37
5-13. Schematic Diagram – Power Section – ···························· 39
5-14. Printed Wiring Board – Power Section – ························· 41
5-15. IC Pin Function Description ············································· 43
5-16. IC Block Diagrams ··························································· 45
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH
MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
1. Check the area of your repair for unsoldered or poorly-soldered
connections. Check the entire board surface for solder splashes
and bridges.
2. Check the interboard wiring to ensure that no wires are
"pinched" or contact high-wattage resistors.
3. Look for unauthorized replacement parts, particularly
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
4. Look for parts which, through functioning, show obvious signs
of deterioration. Point them out to the customer and
recommend their replacement.
5. Check the B+ voltage to see it is at the values specified.
6. Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
SAFETY CHECK-OUT
After correcting the original service problem, perform the following
safety checks before releasing the set to the customer.
6. EXPLODED VIEWS
6-1. Front Cabinet Section ······················································· 49
6-2. Rear Cabinet Section ························································ 50
6-3. Upper Cabinet Section······················································ 51
6-4. Mechanism Deck Section (1) (MF-V5-117) ···················· 52
6-5. Mechanism Deck Section (2) (MF-V5-117) ···················· 53
6-6. Optical Pick-up Section (KSM-213CDP) ························ 54
7. ELECTRICAL PARTS LIST ···································55
To Next Page
Loading...
