Sony CFD-S23 - The CD Player; Playing Tracks Repeatedly; (Repeat Play); Creating Your Own Program

04/30/97
WE0
13:54
FAI
201
930
7982
SONY/GENERAL
AUDIO
Playing tracks
repeatedly
(Repeat Play)
You can play tracks repeatedly in
normal, shuffle or jxogram play modes
(see page 15).
Tips
CfD-S33only.'
• To enjoy a short repeat
play, use LOOP on the
remota
As soon as you press
and hold LOOP during
play, the player alaits a
loop play of die part
between the point
where you pressed
LOOP and a point
about a second behind.
When you release
LOOP, the player
letums to normal play.
• On the remote, use
MODE instead of
PLAYMODB/MONO/
ST/ISS.
1 Press
"Cd" appears in the dfeplay
2 Press PLAY MODB/WONC/ST/ISSunta the
repeat mode you want appears In flie display.
To repe^_ S elect
a single tjack RIP1
allthetracte ] RIPALL
toachainfvndom fwHer SHUPREP
progcamri tracks j PCM REP and then pt
PCM REP and then ptogam
tcccks (see step 3 on page
19.
3 DodthcroftheMowii^tostartrqwatplay:
> When you've selected fCP1, select the track by
pressing or ► H and press Wl.
• When you've selected REP ALL, SHUF REP or
PGM REP, press HI,
To cancel Repeat Play
Press PLAYMODE/MOMO/ST/ISS tmai"REP"
disappearsin the display.
The CD Player
Creating your
own program
(Program Play)
You can make a program of up to 20
tracks in the order you want &em to be
played.
Dps
• CFD-SSdonfy:
To create your own
program on the remote,
pro«ed aa follows:
1 Press ■ .
2 Press MODE until
'PGM" appears in
the display.
3 Press the number
buttons for the backs
you wane To prograin
in the order you
want.
IPressH.
• You can play the same
program agidn, since
the program is saved
until you open the CD
compartment.
• You can record your
own program. After
you've created the
program, insert a blank
tape into the
compartment and press
• to start: recording.
1 Press ■ .
"Cd" appears in the display.
2 Press PLAY MODB/MONO/Sr/ISSunm'TGM''
appears in the display.
3 Press / ► Hand press DISPLAY/ENT/MEM
for the tracks you want to program In the order
youwant. Youcaiipragramupto20trad3.
To cancel Program Play
Press PLAY MODE/MONO/ST/ISS until "K3M"
disappears from die display.
To check the order of tracks before play
Press DISPLAY/HNT/MEM,
Every dme you press the button, flte track number
appears in the programed order.
To change the current program
Press ■ once if the CD Is stopped and twice If the CD
Is playing. The current program will be erased. Then
create a new program following the programing
procedure.
The CO Player