CFD-S39
– 37 –
6-13. SCHEMATIC DIAGRAM — POWER SUPPLY SECTION —
– 38 –
• Total current is measured with no cassette installed.
• Voltage and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : DC 9V from battery terminal.
( ) : AC 120V from AC inlet.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
(Page 30)
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
4
W or less unless otherwise
specified.
• C : panel designation.
• U : B+ Line.
Note: The components identified by mark ! or dotted line
with mark ! are critical for safety.
Replace only with part number specified.
To Next Page
Loading...
