20
GB
Setting the
Automatic Standby
function
The system enters Standby mode
automatically in about 15 minutes when
there is no operation or audio signal output
(Automatic Standby function).
By default, the Automatic Standby function
is turned on.
1
Press / to turn on the
system.
2
Press and hold / for more
than 3 seconds.
“AUTO STANDBY ON” appears on the
display window .
To turn off the function, repeat the
same procedure. “AUTO STANDBY OFF”
appears on the display window and
the function turns off.
When the system enters Standby mode,
“STANDBY” appears and blinks 8 times in the
display window
.
The Automatic Standby function is invalid for the
tuner function (FM), even when you have
enabled it.
The system may not enter Standby mode
automatically in the following cases:
while using the FM function
while an audio signal is being detected
during playback of audio tracks or files
while the Play Timer or Sleep Timer is being
used
The system counts down the time (about
15 minutes) again until it enters Standby mode,
even when Automatic Standby function is
enabled in the following cases:
when a USB device is connected in USB
function
when a button on the remote or unit is
pressed
Additional information
To Next Page
Loading...
