COM-2.US.3-213-855-11(1)
176
176
Symptom Cause or corrective action
The computer freezes
when the power is turned
on after connecting the
unit. The computer displays
“boot from CD“ on the
screen.
Be sure to connect the unit after turning on the power
of the computer.
Symptom Cause or corrective action
HOME button does not
work.
A dialog window is displayed. Close the dialog window
by selecting “OK,” “Cancel,” “Close,” etc.
The unit does not function
properly.
Static electricity and other similar occurrences may
affect the operation of the unit. Remove the battery pack
and AC adapter, wait for a few minutes. Then turn on
again.
P
ress the RESET button using the stylus to reboot the
unit (
page 15).
The unit or AC adapter is
warm.
During use, the unit or AC adapter may become warm.
This is not a malfunction. If you find the AC adapter
gets extremely warm, stop using the unit, and unplug
the AC adapter from the power source.
The unit is turned on, but
does not operate.
None of the buttons or controls work while the start-up
screen is displayed.
C
heck that the POWER/HOLD switch is not set to
“HOLD” (
page 15).
T
ry sliding the POWER/HOLD switch and holding
until the POWER indicator turns off. The unit will be
completely turned off. Then turn on the unit again.
P
ress the RESET button using the stylus to reboot the
unit (
page 15).
R
emove the battery and remove the AC cord or USB
cable. Wait a few minutes, insert the battery, and then
plug the AC cord in before turning on the unit again.
The keyboard does not
work.
Check that the POWER/HOLD switch is not set to
“HOLD” (
page 15).
C
heck that the modifier keys (the Fn key, the Num key,
the Sym key and the Shift key) are not locked (
page
20).
Continued
To Next Page
Loading...
Need help?
General