COM-2.US.3-213-855-11(1)
180
180
If fingerprints or dust make the LCD screen dirty, it is recommended you use a soft
cloth to clean it.
When you use the LCD Cleaning Kit (not supplied), do not apply the cleaning
liquid directly to the LCD screen. Use a cleaning cloth moistened with the liquid.
Wipe the camera lens with a soft cloth to remove fingerprints, dust, etc.
Clean the unit surface with a soft cloth slightly moistened with water, then wipe
the surface with a dry cloth. Do not use the following as they may damage the
finish or the casing.
Chemical products such as thinner, benzine, alcohol, disposable cloths, insect repellent,
sunscreen or insecticide, etc.
Do not touch the unit with the above chemical products on your hand.
Do not leave the unit in contact with rubber or vinyl for a long time.
• Your Personal Communicator is designed for use within the temperature
range of 41 to 95°F (5 to 35°C). Using in extremely cold or hot places that
exceed this range is not recommended.
•
The unit may heat up during use due to the operation of its internal circuitry.
This is not a malfunction. The temperature of the unit varies, depending
upon the operations it is performing. Do not hold the unit for a long time in
such a case.
In the unit is brought directly from a cold to a warm location, moisture may
condense inside or outside the unit. This moisture condensation may cause a
malfunction of the unit.
Turn off the unit and wait about an hour for the moisture to evaporate. Note
that if you attempt to shoot with moisture remaining inside the camera lens,
you will be unable to record clear images.
Continued
To Next Page
Loading...
