How to fix 'OUT OF SCAN RANGE' on Sony CPD-G500 Marketing?
If 'OUT OF SCAN RANGE' appears on your Sony Monitor, it means the input signal is not supported. If you replaced an old monitor, reconnect it and adjust the computer's graphic board so that the horizontal frequency is between 30 - 121 kHz, and the vertical frequency is between 48 - 160 Hz. 'CHANGE SIGNAL TIMING' should appear on the screen.
What to do if NO INPUT SIGNAL appears on Sony CPD-G500 Marketing Monitor?
If the 'NO INPUT SIGNAL' message appears on your Sony Monitor, ensure the video signal cable is correctly connected and all plugs are firmly seated. If you're using the five BNC connectors, verify they are connected in the correct order: Red-Green-Blue-HD-VD from left to right.
What to do if there is no picture on my Sony CPD-G500 Marketing?
If there is no picture on your Sony Monitor, check the following: * Ensure the power cord is properly connected if the power indicator is not lit. * Verify the power switch is in the 'on' position. * If the 'NO INPUT SIGNAL' message appears and the power indicator is orange or flashing, check the video signal cable connection, ensure the INPUT switch setting is correct, and inspect the HD15 video input connector for bent or pushed-in pins. * If the power indicator is green or flashing orange, use the Self-diagnosis function.
General| Marketing Model | CPD-G500 |
|---|---|
| Resolution | 1600 x 1200 |
| Aspect Ratio | 4:3 |
| Dot Pitch | 0.24 mm |
| Screen Size | 21 inches |
| Refresh Rate | 85 Hz |
| Input Connectors | VGA |
Important safety warnings, FCC compliance, and regional notices for safe operation.
Safety guidelines for power, proper installation locations, and cleaning procedures.
Explains HD15 and BNC connectors, including pin assignments and signal types.
Steps to verify included items and connect the monitor to various computer types.
Connect power, turn on, and resolve common 'no picture' or signal errors.
Detailed steps for using the control button to navigate, select, and adjust menu items.
How to adjust brightness and contrast, and reset monitor settings to default.
Procedures for resetting single or all monitor adjustments to factory defaults.
A table listing common symptoms and corresponding checks and solutions for troubleshooting.
To Next Page
