To Next Page
M
michaelsalinasSep 9, 2025
How to adjust white balance on my Sony CPD-E500 Marketing?
- VVictoria TaylorSep 9, 2025
Adjust the color temperature settings on your Sony Monitor to make white appear correctly.
How to adjust white balance on my Sony CPD-E500 Marketing?
Adjust the color temperature settings on your Sony Monitor to make white appear correctly.
How to fix a Sony CPD-E500 Marketing if the power indicator is not lit?
First, ensure that the power cord is properly connected to the Sony Monitor. If it's still not working, check that the power switch is in the 'on' position.
What to do if my Sony CPD-E500 Marketing shows NO INPUT SIGNAL and the power indicator is orange?
First, check that the video signal cable is properly connected to your Sony Monitor and all plugs are firmly seated in their sockets. Also, inspect the HD15 video input connector’s pins to ensure they are not bent or pushed in.
Why is my Sony CPD-E500 Marketing picture fuzzy?
Try adjusting the brightness and contrast settings on your Sony Monitor. You can also try degaussing the monitor. If 'CANCEL MOIRE' is turned on, the picture may become fuzzy, so decrease the moire cancellation effect or turn 'CANCEL MOIRE' off.
How to resolve OUT OF SCAN RANGE message on my Sony CPD-E500 Marketing Monitor?
Verify that the video frequency range is within the specifications for your Sony Monitor. If you replaced an old monitor, reconnect it and adjust the frequency range to Horizontal: 30 – 109 kHz and Vertical: 48 – 160 Hz.
How to fix non-uniform color on my Sony CPD-E500 Marketing?
First, try degaussing the Sony Monitor. Equipment that generates a magnetic field, such as a speaker, placed near the monitor, or changing the direction the monitor faces, may cause color to lose uniformity. Also, try adjusting the landing.
Why are there thin lines on my Sony Monitor screen?
The thin lines you see on your Sony Monitor screen are normal for the Trinitron monitor and are not a malfunction.
What does NO INPUT SIGNAL mean on my Sony CPD-E500 Marketing Monitor?
The message 'NO INPUT SIGNAL' on your Sony Monitor indicates that no signal is being input to the monitor.
How to fix red or blue shadows on text on my Sony CPD-E500 Marketing?
Adjust the convergence settings on your Sony Monitor to eliminate red or blue shadows on letters and lines.
Why does my Sony CPD-E500 Marketing say OUT OF SCAN RANGE?
The 'OUT OF SCAN RANGE' message on your Sony Monitor indicates that the input signal is not supported by the monitor’s specifications. If 'CHANGE SIGNAL TIMING' appears, and you replaced an old monitor, reconnect the old monitor and adjust the computer’s graphic board so that the horizontal frequency is between 30 - 109 kHz, and the vertical frequency is between 48 - 160 Hz.
Important warnings about using the correct power cord for safe operation.
Instructions for connecting the monitor to different computer types.
Procedure for connecting the monitor to a power source.
Explains common on-screen messages and their meanings.
Troubleshooting steps for when the monitor displays no picture.
Solutions for picture instability and scrambling.
Steps to improve picture fuzziness, including degaussing and moire settings.
Steps to perform self-diagnosis when the power indicator is green.
General| Screen Size | 21 inches |
|---|---|
| Viewable Size | 19.8 inches |
| Dot Pitch | 0.24 mm |
| Vertical Refresh Rate | 50-160 Hz |
| Bandwidth | 300 MHz |
| Input Signal | Analog RGB |
| Aspect Ratio | 4:3 |
| Display Type | CRT |
| Refresh Rate | Up to 160 Hz |
| Horizontal Refresh Rate | 30 kHz - 121 kHz |
