68
GB
Other operations
Notes
• You cannot activate the Play Timer and Rec Timer at
the same time.
• If you use the Rec Timer and the Sleep Timer at the
same time, the Sleep Timer has priority.
• The system turns on 30 seconds before the preset
time. Do not operate the system from the time the
system turns on until the play starts.
• The Rec Timer will not be activated when the
following occurs 30 seconds before the preset time.
– The system is turned on.
– “STANDBY” is blinking in the display.
• The volume is reduced to minimum during
recording.
The demonstration display (display window and
buttons lighting even when the system power is
off) and the clock display can be turned off to
minimize the amount of power consumed during
standby (Power Saving Mode).
Press DISPLAY repeatedly while the
system is off until the demonstration
display or the clock display disappears.
To cancel Power Saving Mode
Press DISPLAY while the system is off. Each
time you press the button, the display switches
cyclically as follows:
Demonstration display t Clock display* t
No display (Power Saving Mode)
* The clock is displayed only if you set the clock.
Tips
• The timer continues to operate in Power Saving
Mode.
•
?/1 indicator lights up even in Power Saving Mode.
Press DIMMER on the unit repeatedly to
turn the display on or off while the system
is on.
Each time you press the button, the display
changes cyclically as follows:
DIMMER 1 t DIMMER 2* t
DIMMER OFF
* DIMMER 2 is the darkest.
To Do this
Check the setting 1 Press TIMER MENU.
2 Press M or m repeatedly
until “TIMER SEL?”
appears, then press ENTER.
3 Press M or m repeatedly
until “REC SELECT?”
appears, then press ENTER.
Change the setting Start over from step 1.
Cancel the timer
1 Press TIMER MENU.
2 Press M or m repeatedly until
“TIMER SEL?” appears,
then press ENTER.
3 Press M or m repeatedly until
“TIMER OFF?” appears,
then press ENTER.
Display
Turning off the display
— Power Saving Mode
Adjusting the brightness
of the display
To Next Page
Loading...
