[ 11 ] two screws
#247 (M1.4 X 2.5)
(0.12 ± 0.01 N·m)
(Note 1)
[ 5 ] two screws
#333 (M1.4 X 1.4)
(0.12 ± 0.01 N·m)
[ 16 ]
[ 1 ] VF side guard (64200)
[ 2 ] Microphone rubbers
[ 3 ] Eye sensor cushion (64200)
[ 4 ] Lens cover sheet (64200)
[ 7 ] Lens cover (64200)
[ 8 ] SE-1016 flexible board
[ 10 ] Microphone cushions
[ 9 ] Sheet lens cover (64200)
[ 22 ] FP-2424
flexible board
[ 17 ] Insulating sheet
(L) (64200)
[ 18 ] Insulating sheet
(R) (64200)
[ 19 ] ST holder
protection sheet
[ 12 ] ST aluminum cover (64200)
[ 23 ] Interception sheet (64200)
[ 14 ] ST cover inner (64200)
[ 15 ] Magnet
[ 24 ] Flash unit
[ 9 ] Sheet lens
cover (64200)
[ 20 ] Protection sheet (R) (64200)
[ 21 ] Protection sheet (L) (64200)
[ 13 ] Gasket (ST) (64200)
Install direction
Blue line
[ 6 ] Claws
Refer to "Notes on Assembling the
SE-1016 Flexible Board (1) (2)".
Refer to "Notes on Assembling
the Microphone Rubbers".
Refer to "Notes on Assembling
the Eye Sensor Cushion (64200)".
Refer to "Notes on Assembling
the Sheet Lens Covers (64200)".
Refer to "Notes on
Assembling the Sheet
Lens Covers (64200)".
Refer to "Notes on Assembling
the Gasket (ST) (64200)".
Refer to "Notes on Assembling
the Flash Unit".
Refer to "Notes on Assembling
the Microphone Cushions".
This screw cannot be reused. Discard the screw removed
once in servicing. Instead, use a new screw.
Note 1
このねじは再利用する
ことができません。
サービス対応時に一度でも外した場合は新品のねじと交換
してください。
To Next Page
Loading...
