[ 1 ] LC blind sheet (64200)
[ 4 ] Sheet LC (pull magnet)
[ 2 ] four screws
#239 (M1.4 X 1.4)
(0.12 ± 0.01 N·m
(Note 1)
[ 3 ] LCD Panel Section
[ 5 ] screw
#276 (1.4 X 3.0)(Tapping)
(0.12 ± 0.01 N·m)
[ 6 ] MIC frame (64210)
[ 7 ] MIC holder (64210)
[ 8 ] Cabinet (rear) assy (64210)
[ 9 ] Control switch block (SW63900)
[ 10 ] RE (64210) insulating sheet
[ 11 ] RE protection sheet (64210)
[ 13 ] Insulating sheet (64210)
[ 14 ] Frame sheet (64200)
[ 15 ] Main frame assy (64210)
[ 5 ] screw
#97 (M1.4 X 1.4)
(0.12 ± 0.01 N·m)
[ 12 ] RE-1004 flexible board
Refer to "Notes on Assembling
the RE-1004 Flexible Board".
Refer to "Notes on Assembling
the Insulating Sheet (64210)".
Refer to "Notes on Assembling
the RE (64210) Insulating Sheet".
Refer to "Notes on Assembling
the RE Protection Sheet (64200) (1) (2)".
This screw cannot be reused. Discard the screw removed
once in servicing. Instead, use a new screw.
Note 1
このねじは再利用することができません。
サービス対応時に一度でも外した場合は新品のねじと交換
してください。