Sony DSC-RX100M7 - Lens Block; Ornamental Ring a or Barrier Assy Replacing Method

4-3. Lens Block
4-3-1. Ornamental Ring A or Barrier Assy Replacing Method
Removal
1. Turn on the power switch and extend the lens (TELE end).
2. Detach the battery.
3. Apply alcohol to the gap of the Ornamental Plate using tweezers or fine-tipped stick as shown below.
4. Detach the Ornamental Ring A.
5. Pell off the release the Barrier Tape.
Do not reuse these Parts because their adhesive force decreases when they are removed once.
6. Disengage the four claws and remove the Barrier Block Assy.
Bosses
Ornamental Ring A
Do not turn the Ornamental Ring A because there are
Positioning Bosses. Detach the Ornamental Ring A in
the arrow direction.
Note:
Solvent
Tweezers
Note
Barrier Block Assy
Claws
Claws
SYSSET
2023/12/2903:11:18(GMT+09:00)