[ 6 ]
[ 2 ] LC flexible retainer (64200)
[ 3 ] Sheet LC (pull magnet)
[ 22 ] Sheet case
(SY flexible)
[ 21 ] Panel Section
[ 12 ] Cabinet (rear) plate (64200)
[ 13 ] Magnet
(ND7.9X2.9X1.2)
[ 7 ] LC Shield Sheet (64200)
[ 10 ] Magnet (ND7.9X2.9X1.2)
[ 11 ] Sheet LC (pull magnet)
[ 14 ] Plate (pull)
(64200)
[ 15 ] LC cabinet
(rear O) (64200)
[ 17 ] Magnet
[ 20 ] Magnet
[ 18 ] Adhesive sheet cabinet (64200)
[ 19 ] Yoke plate assy (64200)
[ 16 ] LC cabinet
(rear G) (64200)
[ 8 ] Insulating sheet (cabinet rear)
[ 9 ] Plate (pull) (64200)
[ 4 ] three screws
#239 (M1.4 X 1.4)
(0.12 ± 0.01 N·m)
(Note 1)
[ 5 ] two screws
#27 (M1.4 X 2.0)
(0.12 ± 0.01 N·m)
[ 25 ] Hinge assy (64200)
[ 23 ] LC insulating
sheet (case)
[ 24 ] Adhesive sheet
(flex) (64200)
Install direction
Red line
Install direction
Red line
Install direction
Blue line
Install direction
Blue line
[ 1 ] Claws
[ 1 ] Claws
Refer to "Notes on Assembling
the Insulating Sheet (cabinet rear)".
Refer to "Notes on Assembling
the LC Shield Sheet (64210)".
Refer to "Notes on Assembling
the Adhesive Sheet Cabinet (64200)".
Refer to "Notes on Assembling the
Adhesive Sheets (flex) (64200) and
the LC Insulating Sheet (case)".
Refer to "Notes on Assembling the
LC Flexible Retainer (64200)".
Refer to "Notes on Assembling the
Adhesive Sheets (flex) (64200) and
the LC Insulating Sheet (case)".
This screw cannot be reused. Discard the screw removed
once in servicing. Instead, use a new screw.
Note 1
このねじは再利用することができません。
サービス対応時に一度でも外した場合は新品のねじと交換
してください。
To Next Page
Loading...
