Sony DSC-RX100M7 - Page 5

2-1-3. Discharging of the Flash Capacitor
The charging capacitor for the flash has been charged at high voltage. Therefore, there is a possibility of an electric shock if you
directly handle this capacitor.
The high-voltage charge will not be discharged by simply turning off the unit’s power. Make sure any remaining voltage is
discharged by short-circuiting the flash capacitor with a Short Jig.
Preparing the Short Jig
Make a Short Jig by connecting a small clip to each lead of a resistor with a rated value of approximately 1 kΩ/1 W.
In order to prevent an electric shock, wrap insulating tape completely around the resistor and its leads.
Resistor with a rated value of approximately
1 kΩ/1 W (Part No. 1-215-869-11).
Wrap insulating tape c
ompletely
around the resistor and its leads.
Small clipSmall clip
SYSSET
2023/12/2903:11:18(GMT+09:00)