Sony DSC-RX100M7 - Page 7

4-2. Disassembly
• Follow the disassembly procedure in the numerical order given.
• When installing, reverse the steps of removal.
4-2-1. Rear Cabinet Section
[ 1 ] five screws
#352 (M1.4 X 2.5)
(0.12 ± 0.01 N·m)
(Note 1)
[ 7 ] two screws
#368 (M1.4 X 3.0)
(0.12 ± 0.01 N·m)
[ 7 ] two screws
#368 (M1.4 X 3.0)
(0.12 ± 0.01 N·m)
[ 8 ] tilt the LCD
[ 18 ] Rear Cabinet Section
[ 5 ] Speaker blind sheet (64200)
[ 9 ] two screws
#247 (M1.4 X 2.5)
(0.12 ± 0.01 N·m)
(Note 1)
[ 10 ] MIC lid (64210)
(Note 2)
[ 11 ] USB lid (64210)
(Note 2)
[ 12 ] HDMI lid (64210)
(Note 2)
SY Board Section
[ 6 ]
Cabinet bottom (64200)
[ 17 ] BTB holder (64210) RE
[ 16 ] BB cushion (64200)
[ 2 ] open the BT lid
[ 13 ] open the rear cabinet section
[ 3 ] Claws
[ 3 ] Claws
[ 4 ]
[ 15 ]
[ 14 ] Claw
Refer to "Notes on Assembling the
Speaker Blind Sheet (64200)".
Refer to "Notes on Assembling the
BTB Holder (64210) RE (1)(2)".
Refer to "Notes on Assembling the
BB Cushion (64200)".
Refer to "Confirmation after Installation
of the Rear Cabinet Section".
(Note 3)
This screw cannot be reused. Discard the screw removed
once in servicing. Instead, use a new screw.
Note 1
このねじは再利用するこ
とができません。
サービス対応時に一度でも外した場合は新品のねじと交換
してください。
SYSSET
2023/12/2903:11:18(GMT+09:00)