Sony DSR-70 - Setting Edit Points Using the Recorder Only

Selecting an Edit Mode
Chapter 3 Editing
56 Chapter 3 Editing
To modify edit points slightly
Proceed as follows.
1 While pressing the recorder side or player side IN or OUT button,
depending on the edit point that you want to modify, press a TRIM
button (+/MARK or –/LIST) on the same side of the control panel.
The edit point time data is displayed.
Each time you press the +/MARK button, you advance one frame, and
each time you press the –/LIST button you return one frame.
2 After making the modifications, press the IN or OUT button that you
pressed in step 1.
Setting Edit Points Using the Recorder Only
If you press the PLAYER button to light the PLAYER indicator on the
control panel, you can operate the player or an external VCR with the
recorder side buttons, and set edit points.
In this case, it is recommended that you set setup menu item 006 “LOCAL
FUNCTION ENABLE” to ST&EJ (default setting) on the player
beforehand (see page 102).
AUDIO IN
TRIM
LIST MARK
CLIP
LINK
ENTRY SHIFT
IN OUT
–+
DELETE
TRIM+/MARK and
–/LIST buttons
OUT button
IN button
Setting Edit Points