S
spencervillarrealSep 9, 2025
What to do if my Sony DSR-45 VCR displays EE pictures and sound?
- CCharles MyersSep 9, 2025
If your Sony VCR displays EE pictures and sound, check the DISPLAY SET menu. If EE/PB SEL is set to PB, change it to EE.
What to do if my Sony DSR-45 VCR displays EE pictures and sound?
If your Sony VCR displays EE pictures and sound, check the DISPLAY SET menu. If EE/PB SEL is set to PB, change it to EE.
What to do if my Sony VCR's audio is noisy?
If the audio from your Sony VCR is noisy, there are a few potential causes: * The INPUT SELECT selector may not match the signal input. Adjust the selector to match the signal input. * The tape you're using might be damaged. Try removing the cassette and inserting another one. * The video heads could be dirty. Clean the video heads using the supplied cleaning cassette.
Why does my Sony DSR-45 VCR rewind automatically when the tape ends?
If your Sony VCR automatically starts rewinding when the tape reaches its end, it's because the TIMER selector is set to REPEAT. To prevent this, set the TIMER selector to OFF.
What to do if my Sony DSR-45 operates by itself?
If your Sony VCR is operating by itself, check the COMMANDER setting on the OTHERS menu. If it's set to WIRELESS and a Sony Remote Commander (command mode VTR4) is nearby, it could be the cause. Set COMMANDER to CONTROL S to resolve this.
What to do if my Sony VCR's remote control doesn't function?
If the Remote Commander or the Remote Control Unit of your Sony VCR is not functioning, the setting of COMMANDER on the OTHERS menu might be inappropriate. Change the setting of COMMANDER according to the device used.
What to do if my Sony DSR-45 VCR won't power on?
If your Sony VCR won't turn on, the AC power cord might be disconnected. Make sure to connect the AC power cord.
What should I do if moisture condensation has occurred in my Sony DSR-45?
If moisture condensation has occurred in your Sony VCR, remove the cassette, then wait more than one hour with the power on.
Even though the REMOTE/LOCAL switch is set to REMOTE, why does my Sony VCR start recording/playback by itself?
Even though the REMOTE/LOCAL switch is set to REMOTE on your Sony VCR, the unit might start recording or playback by itself because the TIMER selector is set to REPEAT or REC. Set the TIMER selector to OFF.
How to clean dirty video heads on my Sony VCR?
To clean dirty video heads on your Sony VCR, use the cleaning cassette (supplied).
What to do if my Sony DSR-45 playback pause mode is released?
To resolve the issue where playback pause mode is released and the Sony VCR goes into stop mode, set FROM STILL on the VTR SET menu to STEP FWD.
| Video Format | DVCAM, DV |
|---|---|
| Display | LCD |
| Remote Control | Yes |
| Audio Format | PCM |
| Recording Time (DVCAM) | 184 min (with PDV-184ME) |
| Recording Time (DV) | 276 minutes (with DVM-184 tape) |
| Inputs | Analog Composite, Analog S-Video, Analog Component |
| Outputs | Analog Composite, Analog S-Video, Analog Component |
| Control Interface | RS-422 |
| Tape Speed | 18.81 mm/s (DV) |
Loading...