Sony DSX-B700W - Bluetooth Device Management; Pairing New Bluetooth Devices

DSX-B700/B700W/B710D
9
Sony CONFIDENTIAL
For Authorized Servicer
IMPORTANT NOTE OF INITIALIZING
The purpose of “BLUETOOTH Initialize” is to initialize the BLUE-
TOOTH connection history (HF/Audio Streaming). (To delete the
device information for the devices that you connected to when
searching, etc.)
When the MAIN board is replaced, it is necessary to initialize this
unit.
Refer to the following, initialize this unit.
Note: Phonebook data and dialed/received call history can be deleted by
executing “BLUETOOTH Initialize”.
Procedure:
1. In the state of source off (the clock is displayed on the liquid
crystal display), press the [PUSH ENTER MENU/ VOICE]
button.
2. Rotate the control dial, and select the “BLUETOOTH”.
3. Press the [PUSH ENTER MENU/ VOICE] button.
4. Rotate the control dial, and select the “BT INITIAL”.
5. Press the [PUSH ENTER MENU/ VOICE] button, and the
message “INIT-NO” is displayed on the liquid crystal display.
6. Rotate the control dial clockwise, and select the “INIT-YES”
7. Press the [PUSH ENTER MENU/ VOICE] button.
8. When “BLUETOOTH Initialize” is completed, the message
“COMPLETE” is displayed on the liquid crystal display for a
moment.
9. Press the [MODE ] button twice, and return to the state of
source off (the clock is displayed on the liquid crystal display).
OPERATION CHECK OF THE USB
Connect a USB device to this unit for checking the USB operation
of this unit.
Refer to the support site written in the operating instructions for the
details about the compatibility of a USB device.
CANCELING THE DEMO MODE
You can cancel the demonstration display which
appears when the source is off and the clock is
displayed.
1 Press MENU, rotate the control dial to
select [GENERAL], then press it.
2 Rotate the control dial to select [DEMO],
then press it.
3 Rotate the control dial to select [DEMO-
OFF], then press it.
The setting is complete.
4 Press (back) twice.
The display returns to normal reception/play
mode.
NOTE OF REPLACING THE ELECTRICAL PARTS ON
EACH BOARD FOR REPAIRING
Among mounted electrical parts on each board, only parts that are
described in the electrical parts list can be replaced for repairing.
The parts that are not described in the electrical parts list cannot be
replaced with single for repairing.
SYSSET
2019/10/2421:43:03(GMT+09:00)