3-3
DXC-D30WS/P(E)/V1
3-1-5. Adjustment Item
3-2. Before Adjustment
3-2-1. Color Bar Signal Confirmation
3-2-2. Sensitivity Measurement Confirmation
3-3. Camera Adjustment
3-3-1. Sub-Carrier Frequency Adjustment
3-3-2. INT SC-H Phase Adjustment
3-3-3. Y/R-Y/B-Y CLP Level Adjustment
3-3-4. Y/SYNC/R-Y/B-Y Level Adjustment
3-3-5. Carrier Balance Adjustment
3-3-6. Chroma (VBS) Level Adjustment
3-3-7. Y (VBS) Level Adjustment
3-3-8. Y (YC) Level Adjustment
3-3-9. Chroma (YC) Level Adjustment
3-3-10. VF SYNC/BLKG Level Adjustment
3-3-11. CCD Output Level Adjustment
3-3-12. Pedestal Adjustment
3-3-13. Shading Adjustment
3-3-14. Flare Adjustment
3-3-15. MIC LEVEL/MIC Level IND Adjustment
3-3-16. Character Position Adjustment
3-3-17. 4:3 Title Adjustment
(4) When replacing the CCD unit, be sure to
perform the following adjustment items.
3-3-12. Pedestal Adjustment
3-3-13. Shading Adjustment
3-3-14. Flare Adjustment
(5) If the amplitude level of the measured
waveform is blurred on the waveform
monitor screen, set the RESPONSE switch
on the waveform monitor to “LUM” mode.
To Next Page
Loading...
