Help Guide
Wireless/Streaming Microphone
ECM-S1
Attaching the stand
With the stand attached, the microphone can hold itself up for audio recording. It can tilt for angle adjustment as well.
The stand is attached to the microphone at the time of purchase.
To remove the stand
Hold the microphone and then pull out the stand.
Hint
When the stand is not attached to the microphone, you can screw a boom arm (commercially available) to the screw hole for
tripod attachment (1/4 in. in diameter) at the bottom of the microphone with a screw adaptor (commercially available).
Note
When the stand is attached to the microphone, avoid gripping the stand too tightly or waving the microphone around with
excessive force, as this could cause the stand to detach and result in injury. Hold the microphone itself when carrying or handling
it.
5-054-814-11(1) Copyright 2023 Sony Corporation
Push in the projections of the stand to the stand attachment holes on the microphone until the stand clicks
into place.
1
To Next Page
