Sony ECM-S1 User Manual

Help Guide
Wireless/Streaming Microphone
ECM-S1
When the message “This accessory is not supported by the device and cannot be
used.” is displayed on the camera:
Do the following in the listed order.
Note
Make sure that the slide switch is located exactly at the “ANALOG,” “OFF,” or “DIGITAL” position. If the switch is located in
between, the receiver may not work properly.
5-054-814-11(1) Copyright 2023 Sony Corporation
Make sure that your camera is compatible with this unit.
For camera models compatible with this unit, visit the website at:
https://www.sony.net/dics/ecms1/
Note
In combination with any camera model that is not listed on the above website, the unit does not work.
1
To use a camera that is not compatible with the digital audio interface in combination with this unit, set the
slide switch on the receiver to “ANALOG.”
2
Clean the contacts on the receiver and the camera. When either or both of the contacts are soiled with dust
or the like, the camera may fail to detect that the receiver is attached. To clean the contacts, use a cotton
swab or a dry, soft cloth (e.g., a cleaning cloth). Do not use water or chemicals for cleaning.
3
37

Sony ECM-S1 Specifications

General

Type	Digital camera microphone
Bit rate	24 bit
Sample rate	48 kHz
Wireless range	150 m
Microphone type	Table microphone
USB port	Yes
Device interface	Bluetooth/3.5 mm
USB connector type	USB Type-C
Connectivity technology	Wired & Wireless
Control type	Buttons, Rotary
Product color	Black
Power source	Battery
Battery life (max)	13 h
Receiver type	Camera mount receiver
Transmitter type	-
Number of products included	1 pc(s)
Number of microphones included	1