Help Guide
Wireless Microphone
ECM-W3 / ECM-W3S
Charging the built-in batteries
Each of the receiver, the microphone, and the charging case contains a built-in lithium-ion rechargeable battery. Connect
the charging case and a power source with a USB Type-C cable (commercially available) for battery charging.
Note
Before charging the built-in batteries, be sure to turn off the receiver and the microphone.
Battery charging can go on while the receiver and the microphone are turned on. However, placing the receiver and the
microphone in the charging case automatically turns them off. This means that the next time you use the receiver and the
microphone, you must select “OFF” once with the slide switch on the receiver and with the power switch on the microphone, and
then turn them back on.
In the event that the receiver and the microphone are removed from the charging case after battery charging is conducted while
the receiver and the microphone are turned on, placing them back in the charging case without changing the switch selection
does not start battery charging.
Place the receiver and the microphone in the charging case.
Note
Be sure to push in the microphone until it clicks into place. When the microphone is properly seated, its power lamp lights in
orange, indicating that the battery charging has started.
ECM-W3
ECM-W3S
1
To Next Page
Loading...
Need help?
General
