To Next PageTo Next Page
Need help?Do you have a question about the Sony HCD-VZ30AV and is the answer not in the manual?
Details on speaker power outputs, impedance, and input/output terminals.
Details for CD, tape, tuner sections and general system specs.
Power requirements, safety warnings, and critical component information.
Details on model numbers and their corresponding regions/versions.
Essential checks to perform after repair for safe operation.
Class 1 laser info, pick-up handling, and repair precautions.
Diagram and list identifying all controls and indicators on the front panel.
Diagram and list identifying all rear panel connectors and controls.
Steps to remove the upper case and front panel assembly.
Instructions for removing the back panel and main circuit board.
Steps for removing the power transformer and front amplifier board.
Procedures for detaching the CD and tape mechanism decks.
Steps to disassemble the CD base unit and fitting base.
Procedures for removing CD tray, chassis, stocker, and slider sections.
Procedures for installing gears and the slider component.
Steps for installing the stocker and chassis (mold B) sections.
Procedures for MC Cold/Hot Reset, CD Ship, VACS ON/OFF modes.
Instructions for CD Service, AM Tuner Step, and GC Test Modes.
Procedures for MC Test Mode and the Aging Mode sequence.
How to check error history and activate VIDEO CD color-bars.
Safety precautions and torque specifications for mechanical adjustments.
Procedure for deck section adjustments including azimuth.
Specifies locations for adjusting playback heads in Deck A and Deck B.
Procedures for adjusting record bias and level for tape deck B.
Procedures for S-Curve, E-F Balance, and RF Level checks.
Procedure for adjusting the video section frequency.
Important notes on reading PWB/schematics and common abbreviations.
Diagram showing the location of all major circuit boards within the unit.
Overview of signal flow and major components in the tuner, CD, and deck sections.
Diagram illustrating signal paths and component connections in the main section.
Block diagram showing the display control and power supply circuits.
Diagram of signal flow and ICs within the Video CD section.
Detailed schematic of the video board (first half).
Detailed schematic of the video board (second half).
Component layouts for the Video Board, Sides A and B.
Component layouts for the BD Board, Sides A and B.
Detailed schematic diagram of the BD board, including component identification.
Printed wiring board layouts for sensor, switch, and motor boards.
Detailed schematics for sensor, switch, and motor boards.
Printed wiring board layout for the Audio board.
Detailed schematic diagram of the Audio board circuits.
Printed wiring board layout and schematic diagram for the Leaf SW board.
Component layout for the Main Board, first half.
Detailed schematic of the Main Board, first half.
Detailed schematic of the Main Board, second half.
Component layouts for the Panel board and CB SW board.
Detailed schematics for Panel, CD SW, and Sub Panel boards.
Printed wiring board layout for the Sub Panel board.
Detailed schematic diagram of the Sub Panel board circuits.
Oscilloscope waveform examples for various boards.
Printed wiring board layout for the Microphone board.
Detailed schematic diagram of the Microphone board circuits.
Component layouts for the Front Amplifier and HP boards.
Detailed schematics for the Front Amplifier and HP boards.
Printed wiring board layout for the Surround Amplifier board.
Detailed schematic diagram of the Surround Amplifier board circuits.
Printed wiring board layout for the Trans board.
Detailed schematic diagram of the Trans board circuits.
Block diagrams for ICs on BD, Panel, and Audio boards.
Block diagrams for ICs on the Video board.
Detailed pin function descriptions for IC401 on the Main Board.
Pin descriptions for IC401 and other ICs on the Main Board.
Detailed pin function descriptions for IC701 on the Panel Board.
Detailed pin function descriptions for IC502 on the Video CD board.
Details on setting up and using test modes for the CD mechanism.
Exploded diagram showing parts for the upper case assembly.
Exploded diagram and part list for the front panel section.
Exploded diagram and part list for the chassis assembly.
Exploded view and part numbers for the CD mechanism deck (Section 1).
Exploded view and part numbers for the CD mechanism deck (Section 2).
Exploded view and part numbers for the tape mechanism deck (Section 1).
Exploded view and part numbers for the tape mechanism deck (Section 2).
List of electronic components for the Audio board.
Parts lists for BD CD SW, Clamp Motor, and Front Amp boards.
List of diodes, ICs, coils, and transistors for the Front Amp board.
List of resistors, relays, and terminals for the Front Amp and HP boards.
Component lists for IN SW, Leaf SW, Load Motor, and Main boards.
List of capacitors, connectors, and diodes for the Main board.
List of ICs, transistors, and capacitors for the Main board.
List of diodes, terminals, ferrite beads, and ICs for the Main board.
List of transistors and resistors for the Main board.
List of resistors for the Main board.
List of resistors, capacitors, ICs, and jacks for the Main board.
Component lists for Mic Out SW, Panel, and Sensor boards.
List of resistors, switches, and diodes for Panel and Sensor boards.
List of transistors, capacitors, diodes, and switches for Sensor2 and Sub Panel boards.
List of resistors, capacitors, ICs, and transistors for the Surround Amp board.
List of capacitors, connectors, and trimmers for Trans and Video boards.
List of diodes, ICs, jacks, coils, and transistors for the Video board.
List of miscellaneous video board parts and hardware.
Record of revisions made to the service manual, including dates and descriptions.
Details on speaker power outputs, impedance, and input/output terminals.
Details for CD, tape, tuner sections and general system specs.
Power requirements, safety warnings, and critical component information.
Details on model numbers and their corresponding regions/versions.
Essential checks to perform after repair for safe operation.
Class 1 laser info, pick-up handling, and repair precautions.
Diagram and list identifying all controls and indicators on the front panel.
Diagram and list identifying all rear panel connectors and controls.
Steps to remove the upper case and front panel assembly.
Instructions for removing the back panel and main circuit board.
Steps for removing the power transformer and front amplifier board.
Procedures for detaching the CD and tape mechanism decks.
Steps to disassemble the CD base unit and fitting base.
Procedures for removing CD tray, chassis, stocker, and slider sections.
Procedures for installing gears and the slider component.
Steps for installing the stocker and chassis (mold B) sections.
Procedures for MC Cold/Hot Reset, CD Ship, VACS ON/OFF modes.
Instructions for CD Service, AM Tuner Step, and GC Test Modes.
Procedures for MC Test Mode and the Aging Mode sequence.
How to check error history and activate VIDEO CD color-bars.
Safety precautions and torque specifications for mechanical adjustments.
Procedure for deck section adjustments including azimuth.
Specifies locations for adjusting playback heads in Deck A and Deck B.
Procedures for adjusting record bias and level for tape deck B.
Procedures for S-Curve, E-F Balance, and RF Level checks.
Procedure for adjusting the video section frequency.
Important notes on reading PWB/schematics and common abbreviations.
Diagram showing the location of all major circuit boards within the unit.
Overview of signal flow and major components in the tuner, CD, and deck sections.
Diagram illustrating signal paths and component connections in the main section.
Block diagram showing the display control and power supply circuits.
Diagram of signal flow and ICs within the Video CD section.
Detailed schematic of the video board (first half).
Detailed schematic of the video board (second half).
Component layouts for the Video Board, Sides A and B.
Component layouts for the BD Board, Sides A and B.
Detailed schematic diagram of the BD board, including component identification.
Printed wiring board layouts for sensor, switch, and motor boards.
Detailed schematics for sensor, switch, and motor boards.
Printed wiring board layout for the Audio board.
Detailed schematic diagram of the Audio board circuits.
Printed wiring board layout and schematic diagram for the Leaf SW board.
Component layout for the Main Board, first half.
Detailed schematic of the Main Board, first half.
Detailed schematic of the Main Board, second half.
Component layouts for the Panel board and CB SW board.
Detailed schematics for Panel, CD SW, and Sub Panel boards.
Printed wiring board layout for the Sub Panel board.
Detailed schematic diagram of the Sub Panel board circuits.
Oscilloscope waveform examples for various boards.
Printed wiring board layout for the Microphone board.
Detailed schematic diagram of the Microphone board circuits.
Component layouts for the Front Amplifier and HP boards.
Detailed schematics for the Front Amplifier and HP boards.
Printed wiring board layout for the Surround Amplifier board.
Detailed schematic diagram of the Surround Amplifier board circuits.
Printed wiring board layout for the Trans board.
Detailed schematic diagram of the Trans board circuits.
Block diagrams for ICs on BD, Panel, and Audio boards.
Block diagrams for ICs on the Video board.
Detailed pin function descriptions for IC401 on the Main Board.
Pin descriptions for IC401 and other ICs on the Main Board.
Detailed pin function descriptions for IC701 on the Panel Board.
Detailed pin function descriptions for IC502 on the Video CD board.
Details on setting up and using test modes for the CD mechanism.
Exploded diagram showing parts for the upper case assembly.
Exploded diagram and part list for the front panel section.
Exploded diagram and part list for the chassis assembly.
Exploded view and part numbers for the CD mechanism deck (Section 1).
Exploded view and part numbers for the CD mechanism deck (Section 2).
Exploded view and part numbers for the tape mechanism deck (Section 1).
Exploded view and part numbers for the tape mechanism deck (Section 2).
List of electronic components for the Audio board.
Parts lists for BD CD SW, Clamp Motor, and Front Amp boards.
List of diodes, ICs, coils, and transistors for the Front Amp board.
List of resistors, relays, and terminals for the Front Amp and HP boards.
Component lists for IN SW, Leaf SW, Load Motor, and Main boards.
List of capacitors, connectors, and diodes for the Main board.
List of ICs, transistors, and capacitors for the Main board.
List of diodes, terminals, ferrite beads, and ICs for the Main board.
List of transistors and resistors for the Main board.
List of resistors for the Main board.
List of resistors, capacitors, ICs, and jacks for the Main board.
Component lists for Mic Out SW, Panel, and Sensor boards.
List of resistors, switches, and diodes for Panel and Sensor boards.
List of transistors, capacitors, diodes, and switches for Sensor2 and Sub Panel boards.
List of resistors, capacitors, ICs, and transistors for the Surround Amp board.
List of capacitors, connectors, and trimmers for Trans and Video boards.
List of diodes, ICs, jacks, coils, and transistors for the Video board.
List of miscellaneous video board parts and hardware.
Record of revisions made to the service manual, including dates and descriptions.
General| Type | Mini Hi-Fi System |
|---|---|
| CD Player | Yes |
| Bluetooth | No |
| USB Playback | Yes |
| Speaker Configuration | 2.1 Channel |
| Cassette Deck | Yes |
| Remote Control | Yes |
| Radio Tuner | FM/AM |
| Functions | CD, Radio, USB |
| Speakers | Included |
