Sony HDCU5000 - Page 45

45
<OUTPUT FORMAT IP>
S11
Displayed only when
HKCU-SFP50 is installed.
IP-OUT3 Sets the output for the LAN 1 and LAN 2 connectors.
MONITOR C, M
Sets whether to add characters to the output signal.
C: Characters are not added.
M: Characters are added.
• Fixed to M when SOURCE is set to CAMERA.
• Fixed to C when SOURCE is set to HD TRUNK.
FORMAT FIBER TRANSMIT RATE is HIGH
and SYSTEM is 1.001(525): see
page 54
FIBER TRANSMIT RATE is HIGH
and SYSTEM is 1.000(625): see
page 56
FIBER TRANSMIT RATE is ULTRA
and SYSTEM is 1.001(525): see
page 58
FIBER TRANSMIT RATE is ULTRA
and SYSTEM is 1.000(625): see
page 62
Sets the output signal format of the LAN 1 and LAN 2
connectors.
OETF SDR Sets the gamma curve of the video output.
COLOR BT709
Selects the color space of IP-OUT3 video output.
BT709: Sets the color output format to BT709.
SOURCE CAMERA
, HD TRUNK Selects the signal source to output.
IP-OUT4 Sets the output for the LAN 1 and LAN 2 connectors.
• IP-OUT4 is a setting for dedicated 4K output.
• Output is supported on the HDCU3500 when the
HZCU-UHD35 option is enabled.
MONITOR C Sets whether to add characters to the output signal.
C: Characters are not added.
This is fixed to C.
FORMAT FIBER TRANSMIT RATE is HIGH
and SYSTEM is 1.001(525): see
page 54
FIBER TRANSMIT RATE is HIGH
and SYSTEM is 1.000(625): see
page 56
FIBER TRANSMIT RATE is ULTRA
and SYSTEM is 1.001(525): see
page 58
FIBER TRANSMIT RATE is ULTRA
and SYSTEM is 1.000(625): see
page 62
Sets the output signal format of the LAN 1 and LAN 2
connectors.
OETF SDR
, HDR OETF Sets the gamma curve of the video output.
COLOR BT709, BT2020 Selects the color space of IP-OUT4 video output.
SOURCE CAMERA Selects the signal source to output.
SYSTEM CONFIG
Page name
Page No.
Item Set value Description
Notes
Notes
Note