Sony Hi8 EVV-9000P - Page 34

‘oubleshooting
_
lf
any
difficulty
should
arise
during
operation,
check
through
the
following
list.
Should
the
difficulty
persist,
contact
your
Sony
dealer
or
local
authorized
Sony
service
facility.
|
Symptom
Cause/corrective
measures
|
Power
cannot
be
turned
on.
e
The
battery
is
not
installed.
e The battery is exhausted.
The tape does not run when the
VTR button on the video camera or
on the jens is pressed.
e The tape is at its end.
e
The
cassette
is
in
record
prevention
mode.
(See
page
24.)
*
The
tape
has
sticked
to
the
head
drum.
Remove
the
cassette
and
reinsert
it.
The tape does not run when the
tape transport button on the VTR i
pressed.
e The tape is at its end.
(for details, see the E-E mode
description on page 11.)
s
There
is
no
sound
in
E-E
mode
e
The
POWER
switch
on
the
video
camera
is
set
to
OFF.
e
The
safety
tab
on
the
cassette
is
slid
out
(in
record
prevention
mode).
(See
page
24.)
Power has turned off during
operation.
e The battery is weak.
The
battery
is
quickly
discharged.
=I
e
The
ambient
temperature
is
too
low.
¢ The battery has not been charged fully.
The cassette cannot be ejected.
¢ The battery is exhausted.
e The POWER switch is turned off.
The playback picture is not clear.
Audio recording cannot be made.
The recorded sound is distorted.
The recorded sound is noisy.
34
e
The
video
heads
may
be
contaminated.
Clean
the
heads
using
the
video
head
cleaning
cassette
(not
supplied).
(Do
not
use
a
commercially
available
wet-type
cleaning
cassette.
It
may
damage
the
video
heads.)
e
The
AUDIO
LEVEL
controls
are
set
to
the
minimum
position.
e
The
audio
recording
level
was
too
high.
e The audio recording level was too low.