masterpage:Left
lename[C:\Documents and
ettings\pc13\Desktop\J9031708_4252085411HT5800DPUS\4252085411\GB04BSC_HT-
800DP-US.fm]
18
US
model name1[HT-5800DP]
model name2[HT-4850DP]
-
1 Press input buttons to select the input.
The selected input appears in the display.
2 Turn on the component and start
playback.
Note
If you select the VCR or DVD player, set the
TV’s video input to match the component you
selected.
3 Turn MASTER VOLUME –/+ to adjust
the volume.
Note
To avoid damaging your speakers, make sure that
you turn down the volume before you turn off the
receiver.
To mute the sound
Press MUTING on the remote.
The muting function will be canceled when you
do the following.
• Press MUTING on the remote again.
• Turn the power off.
• Increase the volume.
To use the headphones
Connect the headphones to the PHONES jack.
When the headphones are connected, speaker
output is automatically canceled and “SP” does
not light up in the display.
When MULTI CHANNEL
DECODING indicator lights up
The MULTI CHANNEL DECODING indicator
lights up when the receiver is decoding multi
channel sources.
However, this indicator does not light up if you
select 2CH STEREO mode.
Amplifier Operation
Selecting the component
To select the Press
VCR VIDEO 1
or VIDEO 2
Satellite tuner VIDEO 2
DVD player DVD
MD or tape deck MD/TAPE
CD player CD
Built-in tuner (FM/AM) TUNER FM/AM
GB01COV_HT-5800DP-US.book Page 18 Wednesday, March 17, 2004 5:48 PM
To Next Page
Loading...
Need help?
General
