Control
for
HDMI
The Control
for
HOMI
function
does
not
work.
• Check the HDMI connection (page 9).
• Make sure "CTRL: HDMI"
is
set to "ON" in
AMP menu.
• Make sure the connected component
is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on the
connected component. Refer
to
the
operating instructions supplied with the
connected component.
•
If
you change the HDMI connection, or
connect/disconnect the AC power cord
(main lead), or
if
there is a power failure,
repeat the procedures
of
"Preparing for the
"BRAVIA" Sync" (page 21).
• The system may not work correctly if you
select a component that is not compatible
with the Control for HDMI function on the
TV side.
• Make sure "DVD CTRL", "SAT CTRL" or
"DMPORT. CTRL" is set
to
"ON" in AMP
menu.
No sound is
output
from the system and the
TV's speaker.
• Check the volume of the system and the TV.
• Select the input
of
the system correctly.
The sound
is
output
from both the system and
the
TV.
•
If
the Control for HDMI function
is
set to
off, or the selected component
is
not
compatible with the Control for HDMI
function, tum offthe sound
of
the system or
the TV.
The System Power Off
function
does
not
work.
• Change the setting of the TV
to
tum
connected components off automatically
when you tum off the TV. For details, refer
to
the operating instructions
of
the TV.
An image does not appear on the TV.
• Check whether HDMI IN and HDMI OUT
are connected correctly.
A message stating that the
output
method has
changed
from
the system speaker
to
the TV
speaker, appears
on
the
TV screen.
• The Control for HDMI function for the
selected component is set to off. For details,
refer to "Setting the Control for HDMI
function to off for a component without
HDMIjacks" (page 23).
Other
The remote does
not
function.
• Check that the active subwoofer and the
satellite speaker are connected correctly and
securely.
• Point the remote at the remote sensor
I!i1
on
the satellite speaker.
• Remove any obstacles in the path between
the remote and the satellite speaker.
• Replace both batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on the
remote.
The volume
turns
down
when the
output
method changes from the TV speaker
to
the
system speaker.
• The Volume Limit function is working. For
details, refer to "Using the Volume Limit
function" (page 25).
If
the
system
still
does
not
operate
properly
after
performing
the
above
measures,
reset
the
system
as
follows:
Use buttons on the system for the operation.
1
Press
I/C)
to
turn
on
the
power.
2
Press
INPUT SELECTOR,
VOLUME
-
and
IIC)
at
the
same
time.
"COLD RESET" appears and the system
is
reset. AMP menu, sound field etc., return
to
the default settings.
37
US
-
>
Q.
Q.
a:
o
j
Q)
-
j
0'
"'"
3
a
o'
j
To Next Page
