Sony HVR-M25P - Page 163

6-49
HVR-M25J/M25U/M25N/M25E/M25P/M25C
3. VIDEO OUT Level Check (E-E) (VD-036 board)
Mode E-E
Signal Color bar (VIDEO IN jack)
Measurement Point VIDEO OUT jack (75 Ω terminated)
Measuring Instrument Oscilloscope
Specified value Sync level: A = 286 ± 18 mVp-p(NTSC)
A = 300 ± 18 mVp-p(PAL)
Burst level: B = 286 ± 18 mVp-p (NTSC)
B = 300 ± 18 mVp-p(PAL)
Fig. 6-2-6
4. COMPONENT OUT Adjustment (D1 SMPTE)
4-1. Preparations
Perform the following data setting before the “COMPONENT OUT
Adjustment (D1 SMPTE)”.
Switch setting
1) DISPLAY OUTPUT switch .................................... OFF
2) INPUT SELECT switch ................... VIDEO (except DV)
3) HDV/DV SEL (IN/OUT REC menu) .................... HDV
4) HDMI/CMPNT (IN/OUT REC menu) .................... 480i
5) DOWN CONVERT (IN/OUT REC menu) ... SQUEEZE
Order Page Address Data Procedure
10 0101
20 1001
3CF
Set the bit value of bit0 is
“1”, and press PAUSE
button. (Note)
400
Set the bit value of bit7 is
“1”, and press PAUSE
button. (Note)
50 1000
68 00
Set the bit value of bit1 is
“1”, and press PAUSE
button. (Note)
7Wait for 5 sec.
Switch setting
1) DISPLAY OUTPUT switch .................................... OFF
2) INPUT SELECT switch ...................................... VIDEO
Checking method:
1) Enter the color bar signal to VIDEO IN jack.
2) Set the 60i/50i SEL (OTHERS menu) to “60i”.
3) Check the sync signal level (A) to the NTSC specified value.
4) Check the burst signal level (B) to the NTSC specified value.
5) Set the 60i/50i SEL (OTHERS menu) to “50i”.
6) Check the sync signal level (A) to the PAL specified value.
7) Check the burst signal level (B) to the PAL specified value.
Note: For the bit values, refer to “6-3. SERVICE MODE”, “3-
4. 4. Bit value discrimination”.
H
B
A
3
(13)
8
(18)