Sony HVR-V1C - Page 294

6-130
HVR-V1J/V1U/V1N/V1E/V1P/V1C
3-1-4. Alignment Tapes
Use the alignment tapes shown in the following table.
Use tapes specified in the signal column of each adjustment.
Name Use
Tracking standard (XH2-1) Tape path adjustment
SW/OL standard (XH2-3)
Switching position adjust-
ment
Audio operation check
Audio system adjustment
(XH5-3 (NTSC), XH5-3P (PAL))
System operation check
Operation check
(XH5-5 (NTSC), XH5-5P (PAL))
Fig. 6-3-2 shows the 75% color bar signals recorded on the align-
ment tape for Audio Operation Check.
Note: Measure with video terminal (Terminated at 75 Ω)
Fig. 6-3-2 Color bar signal of alignment tapes
For NTSC model
For PAL model
Color bar signal waveform Color bar pattern
Color bar signal waveform Color bar pattern
3-1-5. Output Level and Impedance
1 V
0.714 V
0.286 V
White (75%)
White (100%)
Yellow
Cyan
Green
Magenta
Red
Blue
Burst signal
0.286 V
Q
I
Horizontal sync signal
(75%)
White
Yellow
Cyan
Green
Magenta
Red
Blue
Q
I
White
(100%)
Black
1 V
0.7 V
0.3 V
White (100%)
Ye llow
Cyan
Green
Magenta
Red
Blue
Burst signal
Horizontal sync signal
0.3 V
(100%)
Ye llow
Cyan
Green
Magenta
Red
Blue
White
Black
Audio/Video output
10-pin connector
Video signal: 1 Vp-p, 75 Ω (ohms),
unbalanced
Luminance signal: 1 Vp-p, 75 Ω
(ohms), unbalanced
Chrominance signal: 0.286 Vp-p, 75 Ω
(ohms), unbalanced (NTSC)
Chrominance signal: 0.3 Vp-p, 75 Ω
(ohms), unbalanced (PAL)
Audio signal: 327 mV (at load
impedance 47 kΩ (kilohms)),
Output
impedance with less than 2.2 kΩ
(kilohms)
COMPONENT OUT jack
Y: 1 Vp-p, 75 Ω (ohms), unbalanced P
B/PR, CB/CR: +/- 350 mVp-p