Sony ICF-C103 - Setting the Alarm

Setting the Alarm
You can set the radio and buzzer alarms. The wake up station is that
preset in number 1.
ALARM MODE
REPEAT ALARM/
SLEEP OFF
2 While keeping the 16] ALARM button pressed, set
the time by pressing the TIME SET/TUNE + or — button.
~ aaa, passer
~ BO
3 Release the 10} ALARM button.
The alarm time is set. The indication becomes the current time.
To set the EJBUZZER) alarm time at 8:15 AM
SLEEP OFF
2 While keeping the [EJEUZZER | ALARM button pressed, set
the time by pressing the TIME SET/TUNE + or — button.
3 Release the ALARM button.
The alarm time is set. The indication becomes the current time.
¢ The wake up station is the PRESET 1 station.
Preset the station you want for the radio alarm in preset button 1.
¢ When you set both and alarms continuously,
perform from steo 2 above.
Set Oe = —
arm eS
onan nr bor~'sSicty a GT ET CEE TES
Press the ALARM MODE button until the alarm you want appears
in the display window.
Each time you press the button, the alarm indication changes as follows.
Press ALARM MODE.
, ren ee |
pu ay a | Radio alarm
Press ALARM MODE. _
. Buzzer alarm
Radio and buzzer
alarm*
No alarm
* if you set the radio alarm and buzzer alarm at the same time, the
tadio alarm sounds.
¢ The selected alarm sounds at the time you set, and automatically
turns off after 59 minutes, unless you turn it off. :
When the radio alarm comes on, indication flashes. if you
want to keep on listening to radio and stop flashing, press the RADIO
ON button.
To stop the alarm
Press the ALARM RESET/RADIO OFF button.
The alarm will sound at same time the next day.
To cancel the alarm
Press the ALARM MODE button until neither RYRADIO} or BIBUZZER| x
appears in the display window.
When you awake to the alarm but want to stay in bed for a few
more minutes, press the REPEAT ALARM/SLEEP OFF bar.
The alarm will be silenced but will come on again after about 8 minutes.
If you want to snooze more, press the bar again. You can use the
snooze alarm function for about one hour.
When the snooze alarm function is operating, the alarm indication
flashes.