Still Image Operations 131
Position of the left side
Position of the right side
Position of the bottom side
5
Press [Freeze Enable], turning it on.
The signals of frame memory source buses 1 and 2 are
assigned to the pair of FMs selected in step 2, and a
freeze is now possible.
6
If necessary, set the mask settings
(
1
p. 131) for the
selected signal.
7
Press one of the following in the <Freeze> group to
write a freeze image to temporary memory.
Frame: Execute frame freeze.
Field: Execute field freeze.
Off: Release the freeze, and delete the recorded freeze
image.
To return to the state immediately before the
freeze after carrying out the freeze
In the <Freeze> group, press [Undo].
Notes
•
When the system power is turned OFF, any freeze
images written to temporary memory are lost.
•
If you change the frame memory to use as in step 2
without saving, all the freeze images in temporary
memory will be lost. However, if the auto store function
is set to on in the Setup menu, freeze images will be
automatically saved whenever you change the selected
target frame memory.
•
For the following signal formats, a field freeze is not
possible.
1080PsF/23.976, 1080PsF/24, 720P/50, 720P/59.94
Saving a freeze image (Store)
You can use the freeze function to save an image that has
been written to temporary memory as a file. You can save
a single image to a single file.
A name of up to eight characters can be applied to a file.
Notes
The following names cannot be used:
CON, PRN, AUX, CLOCK$, NUL
COM0, COM1, COM2, COM3, COM4, COM5,
COM6, COM7, COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6, LPT7,
LPT8, LPT9
3
Press [Enter].
This saves the still image file in memory.
The destination folder is the folder selected in step 4 of
“Freezing an image and writing it to memory”
(
1
p. 130).
If the entered folder name already exists, a message to
confirm overwriting appears.
When the system power is turned OFF, all the files
saved in memory are lost.
To carry out a freeze and store simultaneously
(Freeze and Store)
Press [Freeze & Store], turning it on.
In this state, if you press [Frame] or [Field], this carries out
a freeze, and simultaneously stores a still image file.
Setting a mask
To apply a mask to the signal selected on a frame memory
source bus, use the following procedure in the Frame
Memory >Still >Freeze/Store menu (2512).
Masks can be set separately for frame memory source
buses 1 and 2. However, this section describes settings for
frame memory source bus 1 as an example.
1
Press [Box Mask], turning it on.
2
Set the following parameters.
Notes
When the system power is turned OFF, all the files saved
in memory are lost.
To save a captured image as a still image file, use the
following procedure in the Frame Memory >Still >Freeze/
Store menu (2512).
1
Press [Store].
2
Enter a file name.
3
To link the masks on frame memory source buses 1
and 2, press [Mask Link], turning it on.
Recalling Still Images (Recall)
You can recall an image file saved in memory, and allocate
it to any of the FM1 to FM8 outputs.
To Next Page
Loading...
