Sony ICP-3000 - Circle Settings

USO RESTRITO
Applying Special Effects (Nonlinear Effect Settings) 199
No.
Parameter
Adjustment
1
Curve H
Horizontal curve ratio
2
Curve V
Vertical curve ratio
3
Position H
Horizontal curve center position
4
Position V
Vertical curve center position
No.
Parameter
Adjustment
1
Luminance
Luminance
2
Saturation
Saturation
3
Speed
Speed at which hue changes
Chapter
10
DME
Operations
2 Set the following parameters.
No.
Parameter
Adjustment
1
H
Horizontal lens center position
2
V
Vertical lens center position
Circle Settings
You can set the size of the circle, and make the axis of
modulation vertical.
Applying the Circle effect
In the Non Linear >Circle menu (4141.17), set the
following parameter.
No.
Parameter
Adjustment
1
Radius
Size of circle
To make the axis of modulation vertical
Press [Mod V], turning it on.
The axis of modulation when converting to the circle
becomes vertical.
Panorama Settings
You can set the horizontal and vertical curve ratio, and the
curve center position.
Applying the Panorama effect
In the Non Linear >Panorama menu (4141.18), set the
following parameters.
H&V: The image turns as it is split from the center
into 4 parts: left, right, upper, lower.
H: The image turns as it is split from the center into 2
parts: left, right.
V: The image turns as it is split from the center into 2
parts: upper, lower.
When nothing is selected (Off): There are no splits
and the image turns from the edge.
2 Press [Page Turn], then set the following parameters.
No.
Parameter
Adjustment
1
Radius
Radius of turn part
2
Offset
Amount of turn
3
Angle
Angle of turn
To set the input signal of the back page
1 In the <Back Video> group, select the signal input into
the back page.
Self: Use the same signal as the front page.
Flat: Use a flat color.
Hue Rotation: Gradually vary the hue.
2nd Ch: Use the 2nd channel video signal.
To select “2nd Ch,” it is first necessary to select
the 2nd-channel DME.
For details, 1 “Applying a DME Effect to a Key”
(p. 91), 1 “Selecting the DME channel” (p. 94),
and 1 “Combiner operations” (p. 221).
2 Adjust the following parameters, according to the
selected input signal.
When Flat is selected
No.
Parameter
Adjustment
1
Luminance
Luminance
2
Saturation
Saturation
3
Hue
Hue
When Hue Rotation is selected
Page Turn Settings
There are four modes: H&V, H, V, and Off. You can select
the turn position, the radius of the turned portion, the
amount and angle of turning, and the input video for the
front and back pages.
Applying the Page Turn effect
1 In the <Split Mode> group of the Non Linear >Page
Turn menu (4141.19), select the split mode.
Notes
When using a page turn effect with one channel, the
following restrictions apply.
• In an MKS-6570 or MVE-8000A HD system, parts of
the back page other than the title appear as black when
the input is, for example, a title.