Sony ICP-3000 - Page 145

USO RESTRITO
Managing Images Using a DDR/VTR 145
Chapter
7
Frame
Memory
Notes
For extraction as a pair file, the main file and sub file must
have the same number of frames.
1 In the Frame Memory >Clip >Record menu (2523),
record the tape image as a clip ( 1 p. 138).
2 Open the Frame Memory >File >Auto Extraction
menu (2542).
3 Select a clip (single file) recorded from the tape.
4 Press [Extraction Start].
5 Check the message, then press [Yes].
This starts the extraction, analyzes the currently
selected single clip, and automatically extracts a
movie (Clip) or still image (Still). When there is key
data, a pair file is created.
To check the details of the images (still image/
clip)
Set and check the following parameters.
No.
Parameter
Adjustment
1
No
File number
3
Viewer
Timecode for selected image