Chapter
9
Special
Functions
Creating an image with side flags
For example, to create an image with side flags in the
background B row of the M/E-1 bank, use the following
procedure.
1
In the 1st row of the cross-point control block of the
M/E-1 bank, hold down the [UTIL1] button, and in the
2nd row, select the signal (utility bus signal) you want
to insert in the side flag areas.
2
In the background B row, press the cross-point button
Wipe from a 4:3 image to another 4:3
image (when side flags are on for both
images)
Side flag area
corresponding to the 4:3 video material.
At this point, if auto side flags are on, this
automatically adds side flags to the 4:3 video material.
For details,
1
“Setting the Side Flag Video Material
and Operation” (p. 347).
3
Use either of the following methods to turn the side
flags on.
•
Use the Misc >Enable >Side Flags menu (3213)
(
1
p. 154).
•
Use a cross-point button operation
(
1
p. 154).
This adds side flags to the 4:3 video material.
4:3 image
(side flags on)
The circles indicate the position
of the wipe pattern edge when
the transition is half finished.
Side flag area
Wipe Action on Images with Side
Flags
When a wipe is carried out on an image with side flags, all
wipe patterns can be used.
The following show the action in a wipe.
Wipe from a 4:3 image to a 16:9 image
Side flag area
16:9 image
4:3 image
(side flags on)
DME Wipe Action for an Image with
Side Flags
When a DME wipe is carried out on an image with side
flags, all wipe patterns can be used.
Depending on the on/off setting of [Auto Crop] in the
Engineering Setup >Switcher >Config menu (7331), the
appearance of the 4:3 image changes.
Notes
On the MVS-6520/6530/3000A, side flags are not applied
when auto side flags is turned off for signals with the
following DME wipe pattern selected on the DME external
video bus (gray part shown in the pattern illustration).
-
Two-channel frame in-out
-
Two-channel brick
The following show the action in a DME wipe.
To Next Page
Loading...
