Sony ICP-3000 - Page 214

USO RESTRITO
214
Applying Special Effects (Lighting and Recursive Effects)
Chapter
10
DME
Operations
2 Set the following parameters.
No.
Parameter
Adjustment
1
Shape Ptn
Shape pattern
a)
2
Size
Shape size
3
Deform
Amount of shape deformation
b)
4
Soft
Softness of shape pattern
5
Angle
Angle of shape pattern rotation
a) For more information about the shape patterns, 1 “Shape Patterns”
(p. 419).
b) Smaller values make the pattern more rounded.
To rotate the shape pattern
1 In the Light 1 menu (4156.3), press [Shape Speed],
turning it on.
The display for the 5th parameter that was visible
when [Shape] was selected changes.
2 Set the following parameter.
No.
Parameter
Adjustment
5
Speed
Rotation direction and speed
To change the light to a ring shape
Notes
If you select [Parallel] or [Whole] ( 1 p. 213) in the <Spot
Mode> group and shaping is disabled, the Ring parameter
cannot be set.
1 In the Light 1 menu (4156.3), press [Ring], turning it
on.
2 Set the following parameters.
No.
Parameter
Adjustment
1
Offset
Offset from center position
(radius)
2
Radius
Radius of ring
3
Angle
Rotation angle of ring
Notes
There is no Radius setting when [Line] is selected in
the <Spot Mode> group.
To rotate the ring
1 In the Light 1 menu (4156.3), press [Ring Speed],
turning it on.
The display for the 3rd parameter that was visible
when [Ring] was selected changes.
2 Set the following parameter.
No.
Parameter
Adjustment
3
Speed
Rotation direction and speed
To invert the lighted area
In the Light 1 menu (4156.3), press [Light Invert], turning
it on.
To add color to the light source
1 Open the Light 1 >Light Color Adjust menu (4156.4).
2 In the <Fill Blending Mode> group, select how the
light and image should be blended.
Mix: Light as if reflected from a mirror.
Multiply: Light as if reflected from a dull surface
(diffuse reflection).
3 If you selected [Mix], select the fill color in the <Fill
Source> group.
Flat Color: Monochrome color matte
Hue Rotation: Color matte with a color that gradually
varies.
4 According to the selection, set the following
parameters.
When Flat Color is selected
No.
Parameter
Adjustment
1
Luminance
Luminance
2
Saturation
Saturation
3
Hue
Hue
4
Brilliancy
Brilliance of surface struck by
light
When Hue Rotation is selected
No.
Parameter
Adjustment
1
Luminance
Luminance
2
Saturation
Saturation
3
Speed
Speed at which hue changes
4
Brilliancy
Brilliance of surface struck by
light
Copying or swapping light source settings
You can copy or swap the setting from one light source
(Light 1 to Light 3) to another light source.
1 In the Spot Lighting menu (4156), press [Copy/Swap].
The Copy/Swap menu (4156.2) appears.